Search results

  1. M

    Lots of work done to my MSP. Some problems afterwards.

    I had a blown LSD back in early last October. I finally picked up my MSP yesterday and it now has a good used transmission in it. My mechanic also replaced my struts and springs with low mileage factory units. and swapped in my wastegate actuator for a good working unit. I had put a new turbo in...
  2. M

    Bizarre behavior when cornering.

    To preface, the mods in my sig are for my original MSP. I now own another one and have yet to really figure out what the previous owner has done with the suspension. I know this much, it sits really low. Too low. Like my first MSP did with Goldline springs on it, which were replaced with...
  3. M

    Engine and turbo issues...I'm just sick over the problems.

    My sig info is for my previous MSP. I haven't updated it yet. I had it for eight years, and that car was as close to perfect as a car can get. No issues and compression was still 190-195 in every cylinder at 150k miles. When I bought my 2nd MSP with only 110k miles on it, I expected a lot better...
  4. M

    Turbo went out, can't find replacement.

    This is my first time posting in a long time. I have another Spicy MSP now and hadn't driven it much before the turbo went out the other day. I have a shop nearby ready to do the swap for a fair price, but I can't find a replacement turbo. I'm trying to avoid getting a brand new one, but am open...
  5. M

    R.I.P. to my ultimate car... Sparky. The '03 Spicy Orange MSP

    Well, the "Spicy Curse" has struck again. I had mine for 7.5 yrs and 155k mostly trouble-free miles. I've run the Tail of the Dragon at Deals Gap many times, and the last time in a storm, and still went balls-out, with only fun and no problems. Unfortunately I took a a very well known off...
  6. M

    Frozen caliper slide - are rebuilt MSP calipers available?

    The non-bolted caliper slide on my R front is nearly seized. I can swing the caliper apart just far enough to swap the pads, but it won't slide side-to-side apart far enough to get the new pads over the rotor. I figure I should just replace the caliper. I searched for info, but didn't find...
  7. M

    Shimmy in the steering wheel

    Hey all. I've been getting a shimmy/shake in the steering wheel for a while now. It shows up about 45-55 mph and gets worse to 75-80 mph (as fast as I've had it lately). It definitely comes in harder when I'm under load or accelerating, and eases a bunch as soon as I let off the gas. I got...
  8. M

    Need exhaust hanger help

    Hey all. Been away for a while, sorry. Both of my Kartboy exhaust hangers in the front have broken and I don't see anything for the MSP offered on their website now. I tried to contact them some time back and I'm not even sure they are still in business. Is anyone making a performance...
  9. M

    For Sale - New shift and e-brake boots for a Spicy, 3 gauge din panel

    First up is a set of shift and e-brake boots for a spicy MSP. They are black leather with orange stitching, and are brand new and never installed. Instructions are included. $35 shipped for the pair. (Will not separate). Next is a din sized panel with cutouts for 3 gauges, and I believe it is...
  10. M

    Fog lights, new MSP Springs, Walbro 255 and K&N

    I'm selling off some more of my treasure trove of spare parts. I'm a little rusty on my pricing, so all prices are OBO (or best offer). Just don't waste my time with obvious lowball offers. All items are sold as-is. First up are a set of fog lights for a 2003 MSP or for any Protege 5. These...
  11. M

    Need splitter part number

    I did search first. No luck. As title says, I need the part number for the splitter on my Spicy. (The black plastic wing-looking thing that runs all the way under the front edge of my bumper cover). I need a new one and the body shop and dealership both say it's not in the parts catalog. Any...
  12. M

    WTB 1 or 2 '03 RH MSP wheels, or maybe a set of something else?

    As stated, I'm looking for one or two '03 MSP Racing Hart wheels. I have to have at least one, and could probably use two. They would need to be in good condition, with no major rash or damage. I would also consider a full set of aftermarket wheels, but it would depend on if I liked the...
  13. M

    WTB - MSP 4-point lower tie brace - ASAP!

    I don't know what it's officially called, but it's the fairly large black stamped metal factory piece that uses four bolts and runs under the firewall area. Mine is bent and I had to remove it because it was digging into my Vibrant exhaust. I need a replacement, cheap and fast. Hit me up.
  14. M

    Axle reinstallation trouble

    Yes, I searched, with the usual s*** results. I'm installing new axles, and I cannot get the driver's side axle back in. I always have trouble with it, but this time it's worse. I even swapped the c-clip over from my old axle because it looked a little more uniform in roundness, but still no...
  15. M

    Are tie rods and ends unique to the MSP?

    Yes, I searched. Yes, I got the same garbage results. Actually, no results searching for tie rod in the MSP section, which is impossible. I HATE the search engine on this forum. I think I've got a bent tie rod and/or something else bent. I hit some leaves in a corner the other day and put...
  16. M

    Are rebuilt axles available for the MSP ?

    Yes, I searched first, but I got the usual worthless results. Tons of unrelated s*** and no help. I love everything about these php style forums except the search functionality. As the title says, I just need to know if rebuilt axles are available anywhere for the MSP. I've never gotten a...
  17. M

    Steering wheel oscillates in 1st and 2nd gears

    Hey all. I've got something going on I can't figure out. When I'm taking off with decent throttle in 1st gear I get a back and forth wiggle of the steering wheel. I only notice it in 2nd if I'm really hard on the gas. It never does it in higher gears, so it's obviously a torque at the wheels...
  18. M

    Might hit Deal's Gap this weekend

    Sup all. If I can, I may head up to the Gap in the next few days. I'm on fall break through Tuesday, and if I can afford to get away for a day, I'll head up there. If so, it would most likely be Sunday. A weekday would likely be free of cops, but the bike and car watching will be better on a...
  19. M

    Heading to the Dragon (Deal's Gap) today!

    Looks like I'm finally going to make it up there, albeit a little later than I wanted. I won't get there till about 2-2:30 pm. Maybe I'll see another forum member there. w00t!!!!
  20. M

    Deal's Gap (Tail of the Dragon) Meet, May 26/27

    Sorry for the delay. Building a new company and things are going gangbusters. Right now I'm thinking the weekend of May 26 & 27 would work out well. In all honesty, I might follow my typical plan and go up Sat. evening and stay in Alcoa, TN at the Airport Days Inn right on US 129 (Alcoa Hwy.) I...
Back