Search results

Im selling my CA tuned unichip. It was tuned for a FMIC, CAI, Turboback exhaust and 10 psi high boost setting. It has the good harness and works perfectly. It holds 11.5:1 to 12.0:1 AFR's under full boost and 1550F EGT's. It is set up for stock fuel injectors. This unit smoothed out the power...

Im selling my CA tuned unichip. It was tuned for a FMIC, CAI, Turboback exhaust and 10 psi high boost setting. It has the good harness and works perfectly. It holds 11.5:1 to 12.0:1 AFR's under full boost and 1500F EGT's. It is set up for stock fuel injectors. This unit smoothed out the power...

Found this on Ebay if anyone is interested. Stock parts http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=220459449230&viewitem=&sspagename=STRK%3AMESELX%3AIT...

Well i just ran a 16 second 1/4 mile with a built motor boosting at 15psi and settling to 12psi. I have a CA tuned unichip and mods list insig. It pulls hard through 4500rmp but flat lines after that, fells like it looses all power. It sounds like the motor revs up and goes nowhere like the...

Well I snapped my LSD in half so while i pull the tranny out i am going to build the motor at the same time. The thing I am not 100% on is the machine work to be done and its details. Here is my parts build list... Wiseco Pistons K1 Rods Clevite Rod, Main, Thrust Bearings Welded LSD from PG ACT...

Well something went wrong. I was around 4500rpm in first gear and pushed in the clutch and heard a pop. Then no responce from the clutch when i put it in second. At first there was a slipping noise that kind of sounded like a spinning clutch but after i parked it there was no noise at all when...

Here is my parts list for a forged motor build K1 Technologies Rods Wiseco 9.1:1 Pistons Clevitte Rod, main, thrust Bearings AWR 95 Durometer Rear Motor Mount Haltech E6X Standalone ECU 7.5 Lb Fidanza Flywheel ACT Heavy Duty Street/Strip Clutch wrx injectors 440cc Clynder wall honer Piston...

WOW, just installed a custom tuned unichip from CA. It boosts to 9-10psi and bleeds off to 8psi for saftey. Befor hand the car had extreme hesitation that was magnified by the FMIC and Vibrant exhaust. The Unichip fixed it. It runs so smooth now and peels out at will. Guess i got a unit from...

I bought a haltech e6x and i need a base map and msp specific installation instructions or tips. Does anybody have a good base map to tune off of with correct ignition setup? Also is it possible to be able to switch between the stock ecu and haltech ecu via a panel of switches. My concern is...

Im planning on building a monster MSP when i graduate college for mechanical engineering. Its going to have forged internals much like lots of others on the board. Im going to custom build a high flow intake manifold, top mount tubular exhaust mani and custom 3" D.P. Im going to use a huge turbo...

Ok, so I have a FMIC CAI and relocated MAF to the pressurized side and stock exhast. I installed the UNICHIP PnP management to smooth out the power band and it is only the 2nd day ive had it in. I was running at high boost and map A. I was going down the road in 2nd gear and at about 4500rpm...