Search results

You shouldn't need to loosen the bottom bolt as it just a pivot point. If it is too tigh too allow you to adjust the alternator, you can remove the strut brace and whatever the thing attached on that side is and move it out of the way to gain access to the bolt. If you need to remove the...

Try actually removing the pin and checking to make sure the wire is still connected/not corroded on the back side

Tape 2 relays to each other side by side. wire 12volts to pin 85 on both. wire ground to pin pin 30 on both. wire lock wire to pin 86 on one and unlock to pin 86 on other. wire a 1k resistor from pin 27 on lock relay over to pin 27 on unlock relay. run a wire from pin 27 on unlock relay to...

Lock is through a 1k resistor, not 1.5K. Also did you use relays to isolate the lock/unlock wires to the car?

you need to install a relay to bypass the clutch switch during remote start. Pretty easy to do if you know how to wire a relay and understand how to do this kind of stuff. What kind of starter did you put in? Is it a model designed for manual transmission?

The adjustment screws for the alternator are accesible from the top without much trouble, just adjusted mine last week.

Not too bad, I have 6!

I remember when I did mine, I searched for about half hour trying to find it there and couldn't find it, and this is the stuff I do for a living. I finally traced it back from the light itself and found it went down the a pillar instead of the kick panel.

What did you hook the violet/white wire on the pioneer radio harness to? Thats the wire you want hooked up to the reverse wire. The camera power wires I usually extend and run with the video wire up to the radio and make the connections there. That way you know it is fused with the radio and...

Where did you get the reverse wire? The best spot to get it is behind the drivers side a pillar. It is a red/yellow wire. Test it b/f you hook it up. It is a positive trigger wire, so sett up the head unit for that.

Very cool, I will be watching this!

I may have just made a mess in my pants! That thing is sick!

Do like! ^

How much for the shifter surround?

If you are not familiar with wiring or how to use a multimeter, go to a reputable shop in your area and have them install one. It will come with a warranty and be done properly. These are key things. I install them for a living and can't tell you how many hacked installs I have to fix b/c either...

Most any good speaker is going to be a big improvement over the stock ones. Everybody is going to have opinions about which ones are best (I of course am the only one who is right with my focal polyglass components!), but the only one who can decide which is best for you is, well , you. Go to a...

Yeah, a little more info would help with a diagnoses.

I did not hear about this. Maybe I will have to try to check it out. Oh wait, just checked and that is a saturday, gotta work.

I'm in Webster (suburb of Rochester).

I replaced the slave cylinder a few months ago, and although it is better, it is not entirely gone.