Recent content by tddvrrn

hey, i'm looking for a cosmic blue rear bumper cover.. what is up with this crack? if it is in the black insert, that can be replaced. is the crack actually in the bumper cover itself? could you sent me a pic (toddverrone@hotmail.com)? if it's not too bad, i'm in need of a cosmic blue...

prolly well late on this, but for future reference, tweeters up front are 4 ohm, mids in doors (all 4) are 2 ohms.

could you do a close up of the climate control? thanks! mine has a couple small gouges/scratches across the top, i don't want to buy a scratched up replacement.

do it. i'm not sure how much power it will add (search!) but it will increase performance by reducing BATs and eliminating heat soak... if you can get it cheap, do it!

i know i'm resurrecting the dead here, but i don't give a funk... so, i've been loving this fix, but lately there have been a few cds that have some annoying upper mid/lower treble distortion when played loud. i seem to have fixed this by using this: parts express 8.2 uf cap and this: parts...

damn, those are some nice parts! throw an ap in there an you've got yourself a beast kit! glws.. what car are you moving on to?

i had a rattle that sounded like it was coming from the defroster vent. i tried so many ways to fix it. eventually i stuffed some foam padding way up under the dashboard. i reached up from near the accelerator and was able to stuff it under the center of the dash.. no rattles since. if...

i have the jamesbaroneracing ssp. it's great. http://www.jamesbaroneracing.com/store/

i'm not sure what they do. ask some questions. it's probably a fuel induction service. try this: 3m fuel induction kit the only way to really get it clean is to pull off the intake manifold and clean it by hand. but then your valves are still dirty... alas.

bump so someone else can buy them before i end up spending money that i shouldn't..

what parameters does this show? or what useful ones? afr, kr, fuel psi, boost, ltft, timing, bat... whatcha got?

i just used some butyl rope to seal the holes.. the pegs keep the emblem in just fine.. if you need to glue them on, use emblem adhesive. they should sell it at any autoparts store. here: http://www.amazon.com/3M-08061-Plastic-Emblem-Adhesive/dp/B0002MID28

@tomtom, thanks for all the pretty colored fonts.. what did all those words mean? i've never seen them in my golden compass book..

late reply ftl.. mazda is competing with other car makers who put scoops on their cars. everyone has a scoop now. it doesn't mean their better. if you read the file i linked, you will see that the middle of the hood has lower pressure than the front. which MAY mean that the charge is less...

uh, tactful? it's not like i was being a dick, i was just throwing an idea out there. many people would never even think of calling a shipper and sorting out prices for pickup, packaging and delivery. i didn't know if you were one of those people, so i thought i'd throw that out there. maybe...