Recent content by PaPaSpeed

It was nice to see you again. Thanks for posting the pictures.

Still looks good. Even the engine bay is still nice and clean.

Wow! That's a great price. They did treat you good.

You could try to reset the system, if you haven't already. Turn the ket to the on position. 30 seconds approx. Turn key to off position. 30 sec. Start car and drive over 25mph for 15-20 min. Hope the light goes off or stays off. If still on I'd say a sensor is bad. GL

I agree GoFast. I think to OP is going to be disappointed if he tries to use it.

That's kinda why I was asking the question.

Where did you get the #1 O2 sensor for $185? They are usually around $375. Thanks.

You ask tough questions for me to answer. I'll wind up the new PC and see if I can figure out how to do that. I've always had Macs and I'm not too hot on the PC. Jake did the tune real fast and loaded the StandBack, before I knew what was happening, he had it hooked up and told me to test it...

By the time I got the StandBack loaded and running, they were on to the rear wheel and AWD drive cars. So, no I didn't get on this time. I got on at the last one in Feb and did 225 HP.

I attended the CP-e Dyno Day last Saturday, and had a great day. I recently purchased their StandBack and took it over there with me. I talked to Jake (from CP-e) about the installation and tuning. He said bring it over, I'll put a mild tune on it and we'll connect it up. And that's exactly what...

35ftlbs.

Looks great, but the steering wheel is on the wrong side. More pics.