Recent content by Djbradle

You might not get much action here except for a few tumbleweeds. I saw the YT vid of the Tanabe and liked it a lot but I'm biased toward subtle sounds and only installing such a mod if I have the power to eccentuate it like a.....turbo kit ��

So maybe I'm not too up to date but the 2016 Mazda 6 2.2 diesel wagon available in Poland is awd?!? Will they not being this to the states with a 2.5t skyactiv turbo? http://youtu.be/TOOR4scKlpQ

Should be an easy install with gobs of room around and under our engines. I never notice my engine even close to blazing hot even in the summer season. If Ov Tuning's estimates are accurate then maybe the low end of 340-380 bhp and possibly 300 lbs/ft? They claim even better mpg?! I will say...

There's no telling what a difference in low end torque would end up at with that Borg Warner 7163. It would make the car an absolute joy to drive around town and on the highways being such a high compression engine. Kinda scary for reliability purposes running even .5 bar on the 2.5g but who...

It's like an oil thread really. To flush or not to flush? That being said I did a drain and refill x3 with new pan bolts, gasket, and filter in my previous '02 e46 and the fluid was not that bad looking at 190k miles. there was some debris on the magnet but much less than I expected. The shifts...

Powertrain to 60k better cover it. I've had not a single blip with my 6 and at 40k now. Notwithstanding the normal tsb's like Bluetooth, tpms, etc.

I'm definitely toying with the idea as I would really love to have a sleeper Mazda6. I love the platform but the power leaves me wanting. For the $5000 to push up to 340-380 bhp I'd be quite pleased. I don't think I can't wait for a Mazda speed 6 in the future.

Sorry for being late on the pics

A couple issues that have cropped up one being overtime and another from the factory: 1.The lumbar support handle on the driver's side seat created a nice half moon gouge into the leatherette after several uses. The inside edge is sharp so there's no surprise that this happened after further...

You weren't kidding!

Just a followup question; Did anyone ever find good quality led switchbacks for the front and rear turn signals? There are several on aliexpress and ebay but I cannot verify quality and if our cars really need the resistors.

Fat32 format from that Gui worked. Thank you!!

I've been eying some led's that are white when not on and yellow when on. These are them: http://www.ebay.com/itm/like/230872018588?lpid=82 Of course they might need a resistor. They may not fit either; idk.