Recent content by CodyScott

There's corrosion from the old ones and the way it popped off it sits on an angle

The old rotors were old and rusty so I decided to replace them. They were ceased on there. Half a can of pb blaster later I got them off with a dead blow put the new ones on finished the break job but the rotors won't sit flat... What do I do?

Alright thanks man

Loss of horsepower at high rpms and unsteady idle

Alrighrthanks

Does anyone have any recommendations for performance fuel injectors?

When I am stopping in my car I hear a noise that sounds like it's coming from the passenger side wheel it only happens when I'm braking tie rods were replaced is it possible the bearings need to be replaced? If so do they have to be pressed in?

I don't know why you would want to go sideways in a front wheel drive car !!! But thanks so much I was super worried I screwed up the new parts!

So I was teaching my brother to drive stick... Seeing as how he has to drive a stick wrangled home from downtown chicago tomorrow morning and he left my parking brake on for about a mile ... I just replaced the front brake pads and rotors... Please tell me my parking brake in the 2003 mp5 only...

Run the ground wire to the negative post on the battery thanks for the help guys!

Alright I'll respond if this works thanks guys!

And the amp does not power up

I found the remote wire by process of elimination...

The subs never do that initial bump you get when you turn them on all fuses are good the only reason I know power is going to them is cause the multimeter says so

We had just pulled them out of my brothers car and they worked fantastic...