What have you done to your MSP today?

[Spiced MSP]

626 injector seals installed. Good news is no more vac leaks at the seals. Bad news is nothing changed, my car still has the misfire issue and crappy idle. Also, my freaking EGR line won't stay on for some reason. I can put it on and once I drive the car, you will know when it comes off because if you put any load on the engine, it sounds like a big ass exhaust leak. Seriously thinking about getting rid of the EGR but I know I won't pass a state inspection which is coming up in 2 months.

 

[Jaleik]

What troubles me most is the maf high output issue. Could that be caused by an ineficient fuel delivery?

And why are 600cc injectors cheaper than 565cc, dosent make sense to me..

 

[Spiced MSP]

did some reading and of course Im no electrician. But apparently splicing o2 sensors can change the resistance of the wire causing the sensor to act up. After taking some suggestions from a few friends, I swapped o2 sensors a while back with no luck. But I just went to get my CEL read again and I still have the random misfire code along with the heated o2 sensor heater circuit low and now I have a new one, heated o2 sensor circuit high input. So with that being said, splicing the o2 in might be the culprit behind all of this. Does anyone know if you wanted to swap wire harnesses, would you have to go all the way to the ECU? Or is there a separate harness for the engine bay?

 

[VIPMSP]

just got meeeee some

 

[2.0t03speed]

all the way to the ecu

 

[SCMP3]

Could you not just get a plug and play style and call it a day? Or did you cut wires off the harness?

 

[Spiced MSP]

Could you not just get a plug and play style and call it a day? Or did you cut wires off the harness?

I had to cut some of the wire because the manifold burned some of the harness along with melting the connector. How hard is it to pull the harness out?

 

[o0n8]

just got meeeee some

great-buy-guy on ebay?

 

[SCMP3]

Looks like 2/4 of the things I ordered will be here tomorrow. One is still in cali, one hasn't even been shipped. Calling them tomorrow

 

[Knox Joe]

I have to come by here to lurk/post everyday, or I'm afraid I'll lose interest in my MSP. So this is my daily check in...

 

[SCMP3]

Lol don't give up!!!

 

[Preferio]

So, I paid for my pistons on Tuesday.... Still no tracking information available... -_-

 

[2.0t03speed]

you worry too much

 

[SCMP3]

I'm waiting on a tracking number on one of my things

 

[Preferio]

you worry too much

Your face worries too much!

 

[2.0t03speed]

Your face worries too much!

just remember trains, planes, or automobiles betta have my crossbars!

 

[VIPMSP]

great-buy-guy on ebay?

yessir, they were a legit seller/store so i figured why not. GREAT deal on them too.

now my question is... which K1 rods should i get? the pistons are Wiseco K614M835

http://www.campbellenterprises.com/Mazda-Connecting-Rods-FS-DE-Rods_590_127_29.sub

 

[2.0t03speed]

get the standard length 5.315 if you get the long rod you will need custom shorter pistons

 

[Preferio]

5.315" length. If you get the others, you won't be able to use them.

 

[2.0t03speed]

too slow