What have you done to your MSP today?

[Spiced MSP]

turned the boost up a lil, gonna datalog a few pulls later tonight

 

[boostedprotege]

how much u runnin now?

 

[xDJ DUBx]

turned the boost up a lil, gonna datalog a few pulls later tonight

BOOM! lol jk

What boosted said..

 

[boostedprotege]

u know i wish there was a msp here so i cud compare.. u kno stock 25 againts the 28... see what pound for pound difference is lol

 

[Shadow102]

u know i wish there was a msp here so i cud compare.. u kno stock 25 againts the 28... see what pound for pound difference is lol

not much if any at all

 

[boostedprotege]

really??? i'm ssure there is a difference.. the t25 is tiny sittin next to a gt28.. there's gott be a difference in pound for pound..

 

[Shadow102]

really??? i'm ssure there is a difference.. the t25 is tiny sittin next to a gt28.. there's gott be a difference in pound for pound..

if your talking weight wise sure but aside from acutally power differences at 7psi of boost not really. The GT28 opperates better within a higher boost range...if your talking 14psi between the two then yes there is a difference because your reaching the limits of the 25 and pretty much near the lower end of the 28's optimal range.

 

[boostedprotege]

lol well i deff don't mean under 10psi..

 

[Spiced MSP]

how much u runnin now?

BOOM! lol jk

What boosted said..

I haven't really looked at my boost gauge long enough to see what it settles down to. I glanced at it once and it was around 10-11 pounds. Im going to datalog later today hopefully and see what's going on.

 

[boostedprotege]

u need a gauge wit peak hold so you don't have to stare haha... gotta keep your eye on the road

 

[Ricktalife]

Be careful there spiced...I would keep it at 9 spiking 10.

 

[fishdonotbounce]

I just pulled my oil pan and installed a new oil return line and new gasket cause I had a pretty good sized leak going on. The leak looks to be completely taken care of but now I have a good amount of white smoke coming from the tail pipe. I THINK that since I used ammonia cleaner to remove the RTV from the oil pan, some may have stayed in the oil pan even though I wiped it down thoroughly. Once I start driving, the smoking goes away but at idle, it's coming out a good amount. Any ideas?

 

[Spiced MSP]

Be careful there spiced...I would keep it at 9 spiking 10.

yeah, I turned it down a little. Im probably going to go do a lilttle more logging later tonight

 

[SCMP3]

Well as far as my big surprise goes.......


I just put my new ksport coilovers on the msp thursday night and had the car aligned on Friday night. the car handles amazingly. I love it

 

[xDJ DUBx]

You dare post that without pics?

 

[Ricktalife]

Seriously.

 

[TheDirtyGoatee]

Spiced... your Avatar... is.... EPIC.

 

[SCMP3]

I'll take some pics later

 

[Spiced MSP]

lmao, thanks. I found it yesterday just browsing for animated avatars.

By the way, Im boosting 8 pounds with a 9-9.5 psi spike now. Ill probably shoot for 9 with a 10 psi spike later today. According to the SSAFC, my AFRs at 5500 rpm at 9.2 psi were around 12.5 and at about 4600 rpm at 8 psi, my AFR was about 11.3 IIRC. This was all done today at around 3pm in 85 degree weather in third and fourth gears. I will do a little more logging later tonight when it's cooler and see if there is a difference. I just decided to do a third and fourth gear pull while on an entrance ramp getting on the interstate before running into traffic. Then my laptop decided to restart itself to install updates. Perfect timing right? lol... I will log the entire powerband later today when the interstate is a little less congested. Those AFRs are ok for now right?

 

[SCMP3]

by special request....

one of the rears

ground clearence

front

rear

and the reason i didnt go lower

exhaust ground clearence.
the flange started round when i put it on with the sportlines...

and this happened too

plan on possibly changing the exhaust and tires to lower it down some more