will a kartboy shifter fit?

[Striker187]

i ran a search but nobody flat out said it. so will a kartboy shifter fit an msp? also, will it fit the sparco knob (i have a 2003)? ardmp5 is selling them for 80 bucks shipped...sounds like a good deal

 

[Kenetix]

As far as I've heard it fits. The tranni's are exactly the same, cept for beefier CV's and Limited Slip if you wanna be an ass about it.

 

[Striker187]

any chance on it fitting the sparco knob?....i'd really like to keep it

 

[Kenetix]

Well, you can keep the knob. Its a universal piece anyway. Just take off the lower ring, run a small screw through the hole in the knob to keep it tight, and put the ring back on. It would be nice if the threads were the same but I'm not sure. I know you can use it either way though.

 

[t3ase]

ARD MP5 sent me the following reply on this exact topic..

ARD MP5 wrote on 07-26-2003 03:01 PM:
it is a short throw shifter where as yours is not. I think you have the same lever arm as the MP3. Therefore it's much better.

Around $85.00 shipped.

 

[Kenetix]

I thoguht he was talking about one for the MP3. My bad.

 

[derrick1623]

more than likely, the sparco knob will not just thread on, my nardi knob didnt, so i gave it to groharlem, and use a momo knob