stalling

2003 Mazda protege 5 Last week I was parked getting ready to come home and the car stalled, I didnt think much of it because it idles rough so I continued on my way home and the check engine light started flashing and then went into limp mode and stalled again so I parked for about 20 minutes...

Hello! Mazda 6 - late 2006, 2.0 diesel, 89 Kw, 6 speed manual, estate. (My knowledge of cars is limited and dad is helping with stuff - first car) Recently bought used Mazda 6 and for some first couple hundred km it was fine. Then it stalled while driving. Got fuel, oil and battery is...

Description of problem on YouTube https://m.youtube.com/watch?v=YpkCXjnL5dQ

Hi! Long time lurker but first time poster so bear with me =P I have a 2010 Mazda CX9 which just recently started giving problems, specifically the driver's vents wouldn't blow cold air but the rest of them did. Took it to the dealership and they say they fixed the actuator and serviced the A/c...

Hey guys so I've had my MSP for about a year and a half and last month all of a sudden My MSP would have really low idle (400-600rpm) and loss of power until I get to about 4k rpm, then the power would come back. When at idle it would want to stall sometimes. Ever since I replaced the water...

I bought my Mazdaspeed Protege a couple months back and I've had a reoccurring problem where every time I I use my clutch the car just dies. The car isn't stalling and jolting, the clutch initiates as it properly should, but the battery and oil light come on and the engine stops. The car will...

Hello, I have a 2002 Mazda Protege5 (119k miles) with a low idle and a code for Cylinder Misfire #3 (P0303) Now I'll start with this, 3 weeks ago I was driving home from work and my CEL came on. I took it to advance auto right away and discovered 3 issues. P1250 - Fuel Pressure Regulator P1250...

Hi all, TL;DR version below this wall of text. I have had no luck finding solutions on the Rx-8 club forums and was looking to test my luck here. I have a 06 Shinka with 76000 Miles on her second engine. My problems begin way back in September of last year when the car would crank and start...

I've been working on a stalling issue with our 2003 Mazda Protege5. The sequence of events to get it to stall are as follows: 1. Drive for 10-15 minutes 2. Accelerate hard (like you are merging onto the freeway from standstill - we have metered on ramps here). 3. Drive 2-3 miles at highway...

My car has developed idling issues over time and one day didn't start. I had to leave it with my brother a few hours away from home and want to get it worked on. The day it refused to start, the starter was turning over but the engine never fired up. I'm a little beyond the recommended tune-up...

This is my first tread and a question, although I have read lots of posts searching for information, and find this forum very helpful. I recently bought a P5 2003 with 105K km. Did regular maintenance, breaks, spark plugs, thermostat, AUX input for the radio for bluetooth, first oxygen sensor...

Van: 2006 Mazda5 Sport AT A few weeks ago I had the P0715 code come up and the van dropped down to 3rd gear until I stopped. After searching through the forums I found that the turbine speed sensor should be replaced to fix the issue. I replaced it this past weekend along with the rear...

So about a month ago I left my car garaged in AZ because I came out to ohio for my internship. So I had my friend go over and take it for a drive today because I know its bad to leave cars sitting for a long period of time, and i wont be back for another 2 months. While he was driving the car he...

Hope this is in the right area. My wife has a 01 Protoge LX 2.0 and after reading about cleaning the EGR to resolve idle issues thought I would try it. Only the two bolts are severely damaged and the only way off is to cut them. With that being said the car has 230,000Km on it and don't want...

I have a problem with random misfires that i cant figure out. I have recently replaced the spark plugs and wires. i somehow think its related to my intake. I had a friend (without my permission) cut the plastic connecting piece that went near the radiator off, leaving a gaping hole on the intake...