maf

  1. B

    MAF Relocation

    To begin with I have a rebuilt engine with forged internals and a bigger turbo, FMIC w/hardpipes. I just relocated my MAF. Now I can get it to start but it immediately runs really lean and the car dies. Before I relocated the MAF the car ran pretty well. What I was wondering is if I am just...
  2. B

    MAP / MAF Question

    My car is hitting fuel cut at 10psi, so I went out and got a fuel cut defender from Split Second. Now the directions say to connect the wires to the MAP sensor, if you do not have a MAP sensor then it needs to be connected to the MAF sensor. Well I know for a fact that we have MAF sensors on...
  3. K

    Another its been flogged to death already topic

    I know you guys have been asked about 1000 times if not more about this and I do sincerely apologize for it. I just would like some input on this particular case. So I have got to have emissions testing done before the end of September (t-minus 18 days) & I keep popping a P0171 CEL for bank 1...
  4. S

    Rx-8 Shutting off after ignition

    Hi all, TL;DR version below this wall of text. I have had no luck finding solutions on the Rx-8 club forums and was looking to test my luck here. I have a 06 Shinka with 76000 Miles on her second engine. My problems begin way back in September of last year when the car would crank and start...
  5. K

    Bad Fuel Mileage, diagnosis chain?

    Well i am in the process of getting an actual value for my 1999 1.6 L Protege. I will have numbers soon. I am wondering if anyone can advise on a diagnosis path to make sure i am getting the most out of my fuel. Let me say i had a few codes present and my mechanic friend cleared codes and...
  6. M

    ROUGH idle, shifting is off, MPG VERY low.... ive read all forums and tried it all.

    Ok, so everyone with a protege seems to have the same problem, however i dont think the solution has been the same for everyone.. or some ppl just THOUGHT they fixed it with something but it came back.. so here it goes. I have a 02 mazda protege5 2.0 i got the car all messed up, crashed from...
  7. D

    Does anyone know how to fix a Mass Air Flow Sensor????

    I'm thinking no one will but I think it's worth a shot to ask and yes I've searched. I don't want to buy a used one because it could go bad any time and a new one is over 300 bucks.
  8. F

    MAF adjustment

    Hey Guys, since winter cold air has come, I am hitting fuel cut (not just the stumble) but the WHAM cut. From what I gather this comes from the MAF sensor reading 5 volts. I have also been reading into Short term and long term fuel trim (STFT LTFT) I do not like the thought of the joeP...
  9. M

    I aint a noob

    The hesitation returns! feels like the car is pulling timing and dumping fuel. The car bucks and jerks to the point where it's literally decelerating under full throttle - it's horrific to say the very least. I reverted back to superstock map on my afc and put the stock injectors back in (I...
  10. I

    3" MAF. Is it out there?!

    Does anybody know if there is a 3" MAF adapter that will work with the Takeda or F2 CAIs? I heard they might be making/have already made one?
  11. D

    MAF Sensor Wiring Harness..HELP

    OK so I need a little help because this is driving me nuts. About two weeks ago my car starts acting crazy, turns out one of the wires on the Mass air flow connector broke, most likely because the harness was still attached to the battery box causing it to stretch and rip a wire. So it took me...
  12. J

    Intake Installation and P0101 Code

    I've had two customers now who ran into the P0101 code with their intake installations. I want to put some info out so that if people get this code, they'll know what to look for. The code is a MAF Sensor Circuit Malfunction. It is triggered when the MAF readings are out of scale for longer...
Back