Rear seat belts stuck!!!

[albrieva]

Sos! Desperate!

im hurtin here all. my whole assembly us out, and i cant seem to figure out. i twirled it around, as mentioned by some, DIDNT WORK. theres no way ill be able to re-bolt it because its now fully locked, with very little give. has anyone come up with something else? or am i just giving up too soon.... :mad: (blah)

 

[GGKAuten]

I fortunately never had any problems with my seat belts when I ripped my car apart. Not to sure why...of course I left them in the back of my car while driving and stuff so I think they took enough abuse floating around while I drive that they knew they better not get sticky with me or there would be problems.

To add to the ZeN effect however: '"Man who stand on toilet high on pot." and definately always remember "Eagle may fly high, but weisel not get sucked into jet engine." Remember that and nothing can be wrong.

 

[BeNegative]

it has a tilt lock action. u gotta tilt the belt as if it were still bolted, it will release that way but pull the device slowly. it locks again w/ sudden movent. it's like that in event of an accident, it'll lock and keep u in place.

 

[BiGx5MurF]

im hurtin here all. my whole assembly us out, and i cant seem to figure out. i twirled it around, as mentioned by some, DIDNT WORK. theres no way ill be able to re-bolt it because its now fully locked, with very little give. has anyone come up with something else? or am i just giving up too soon.... :mad: (blah)

Ok, I did my strut and spring install about 3 months ago, I read through every single post on this forum at the time, even PMed a few ppl. All that with finese, be patient, be gentle. None of it was working for me. I had the whole assembly out in my room, so I could mess with it while I tried to find more thread on it. Eventually I just swung in around like a mace, I hit my bed with it, my carpeted floor, my woodgrain floor, and after like 2-3 minutes of looking like a maniac, it just came out. Then I just kept pulling it out as much as it will go, and went out to put it back on.

 

[albrieva]

Got It!

Ok so i originally had the full mechanism out, and had no luck. I tried spinning it around and around, but it didnt budge.

So, I put the mechanism back on to the car, not including the bottom bracket connected to the botom of the seat. All I did is exactly what people had said, pulling it LITTLE by LITTLE and VERY SLOWLY... all done... Thanks for the help all..