Hi everyone,
I recently took my 2018 Mazda CX-5 on a road trip from Phoenix to the Grand Canyon. On the drive back, the rear left (driver's side) exterior wheel arch molding (the black textured plastic trim) completely detached and was lost on the highway.
Current Situation:
• The metal fender is intact, but some of the plastic retaining clips are still stuck in the body holes.
• I am looking for the most cost-effective way to replace this.
Questions for the group:
1. Has anyone had success with aftermarket moldings (eBay/Amazon/Walmart) matching the factory textured black finish?
2. Should I buy a specific "clip kit," or do the moldings usually come with the necessary green/orange clips?
3. Are there any specific tricks to getting the new trim to sit flush against the body without it flying off again?
I've attached a photo of the area for reference. Any part numbers or links to reliable aftermarket sellers would be greatly appreciated. Thanks in advance!
I recently took my 2018 Mazda CX-5 on a road trip from Phoenix to the Grand Canyon. On the drive back, the rear left (driver's side) exterior wheel arch molding (the black textured plastic trim) completely detached and was lost on the highway.
Current Situation:
• The metal fender is intact, but some of the plastic retaining clips are still stuck in the body holes.
• I am looking for the most cost-effective way to replace this.
Questions for the group:
1. Has anyone had success with aftermarket moldings (eBay/Amazon/Walmart) matching the factory textured black finish?
2. Should I buy a specific "clip kit," or do the moldings usually come with the necessary green/orange clips?
3. Are there any specific tricks to getting the new trim to sit flush against the body without it flying off again?
I've attached a photo of the area for reference. Any part numbers or links to reliable aftermarket sellers would be greatly appreciated. Thanks in advance!
)
