So you don't remove the other one, you just put this one over it. correct?
p5sundevil said:howd u get confused, the rectangular piece that is around where the ebrake goes into the centor console, yank on that and it pops out, it is a piece of plastic.
then slide the boot on, still following here, you can tell where the ebrake handle ends and the rubber stock "boot" begins, that is where the top of the new boot stops, then let the rest hang DOWN into the rectangular hole. when u put the plastic rectangle piece back in that you popped out it will make the boot fit snug.
YOUR DONE
hehe
=P