Installed my guages, one question..

[jred321]

well, i really dont care where it should or shouldnt be at this point, i was just hopin omeone could help me out?

lol, wish i could
maybe in a different section more people would see it, as many people with the answers would never be in the appearance section

 

[Brian MP5T]

Pooched

the needle sits a good 2 lbs under the box when the car is off??

It's ******. Return It.

2 Inches Of Mercury Not... Lbs or Psi. Common mistake man. No Stess(canada) (p5white)

 

[Brian MP5T]

H2O Temperaturo

well, i really dont care where it should or shouldnt be at this point, i was just hopin omeone could help me out?

As I said man, You might be SOL for a stock sender. Autometer must make an electronic sending unit. If you did get the mechanical one you can remove the housing on the drivers side of the block. It's connected to the Rad top hose. Drill it, tap it, get a brass fitting that fits your temp probe and replace it all useing thread sealent. Aside from that I can't help. That is also where the stock sensor is. Look for it bro.

(mj) (p5white) (mj)

 

[goonsquad]

this isn't an msp specific post, so it shouldn't be in the msp section. just because he has an msp doesn't make this post solely applicable to msp's, it would be the same on all 2000+ (or whatever) protege's, so it shouldn't be in the msp section.
it also isn't an appearance post though...

Quite true. Much greater chance of being answered there though than here.

 

[Got_boost02]

yeah, i figured i would drill and tap it, i was just tryin to find out where it was located. ill look for it though, thanks a lot!