I've seen several EBC's out there. My question is...Has anyone tried making use of that little flip down compartment below the deck for an EBC or anything else? Also isn't there already a hole through the firewall behind there for the stereo to run off the battery? (uhm) Any info would be appreciated. (kiss)
EBC mounting kit
- Thread starter travisto
- Start date
I know it's only my TT, but when I ever get around to buying a GReddy EBC, it'll be going right under mt TT...And there are holes running through the firewall, you just gotta look for them. I know one is on the drivers side, about half way down.
Well mine isn't below the deck, but I have mine under the ashtray in that little pocket. Here's a pic.
As for the hole in the firewall. The only one I've seen is under the driver side dash right above the pedals to the left. Thats where I run my boost hoses and my EBC harness. Hope that helps.
As for the hole in the firewall. The only one I've seen is under the driver side dash right above the pedals to the left. Thats where I run my boost hoses and my EBC harness. Hope that helps.
MazdaSpeedTurbo
Member
- :
- No Car
i will be taking that door off and mounting my apexi avcr in a cf custom peice.. in that area .. except below the cd player
REPLY to REPLY
Thanks for the info. I found the whole! (2thumbs) Usually I only have that problem in the dark... (naughty)
VegasMSP said:Well mine isn't below the deck, but I have mine under the ashtray in that little pocket. Here's a pic.
As for the hole in the firewall. The only one I've seen is under the driver side dash right above the pedals to the left. Thats where I run my boost hoses and my EBC harness. Hope that helps.
Thanks for the info. I found the whole! (2thumbs) Usually I only have that problem in the dark... (naughty)
2K3 Mazdaspeed said:
I was thinking the same thing, the Greddy type II EBC and TT, I was thinking possibly a gauge on the right but I dont think there would be enough room. So I might do side by side and keep the door. I think it would really add to the sleeper look. Also, it keeps thieves away since they wouldnt think anything of it.
Last edited:
I think you might have to trim out part of the inside area. I don't think they will fit side by side or one on top of the other. I'm looking at basically removing the pocket, and only leaving the door to conceal them. The final setup I want will be to have the TT and EBC on the left side, and a single gauge, like an EGT or something on the right. All hidden behind the flapDSM2MSP said:
