CONTINUED -
Perform the "INITIAL LEARNING PROCEDURE" found below.
WARNING : When performing initial learning, be aware of other vehicles, people, and other impediments in order to avoid an accident.
NOTE : While self-learning control gradually reduces shock during normal driving, initial learning is performed to initially learn a certain number of driving conditions.
INITIAL LEARNING PROCEDURE:
a. WARM-UP:
Increase the ATF temperature by leaving the engine at idling or city driving. Verify that the ATF temperature is between 66 - 110 C {151 - 230 F}. If the ATF temperature is outside this range, work to bring it inside the range.
CAUTION : Do not raise the ATF temperature by stalling the engine.
NOTE : If the ATF temperature is not between 66 - 110 C {151 - 230 F}, initial learning cannot be performed. Before learning, inspect for variable shift shock.
b. GARAGE SHIFT MODE:
With the vehicle standing still, depress the brake pedal and keep the selector lever in N position for 3 seconds. Then, shift the selector lever from the N position into D position, and maintain this condition for 3 seconds. Repeat this procedure 5 times. Then repeat it again 5 times in R position.
c. INSPECT LEARNING RESULTS:
Verify that variable speed shock and shift shock have decreased compared to the conditions before learning.
*7. (For TCM Replacement Only): Perform the "TCM NEUTRAL POSITION LEARNING" procedure according to MS3 online or the Workshop Manual (section 05-17 TCM NEUTRAL POSITION LEARNING [AY6AEL, AY6AX-EL]).*
*8. Verify the repair.*