ATP Downpipe installed today!

buit9110

Member
:
Mazdaspeed 6
ATP Downpipe installed today! with dyno!

so the people at japtix installed my downpipe today and I have to say, this car pulls harder than before, I have a dyno for tomorrow at 10am so we'll see how I do. Before the downpipe I put down 262 whp and 279 tq lets see how I do now. what I did notice is that my boost went up to about 17-18 psi.
There is no CEL as of right now and I hope I don't get to see one soon. I'm so exited!! (breakn) (rockon)
 
Last edited:
it actually takes about 40 minutes for the light to come on! is it the catted or non catted? also ill be doing the dioide mode so i should be able to help you out!
 
i've driven it for more than 40 minutes, that's like the distance fom my house to the shop, and after I went to the gym and the grocery store.
 
there are a certain amount of circumstance that must happen before the ECU checks the post cat 02 sensor. it doesn't "check" it all the time. ie it won't check it at wot etc.

mine would vary when it came on. from either 100miles to 15miles.
 
so I dynoed my car today and it put down 272 WHP and 292 TQ I'm so impressed! i can't wait until I upgrade my turbo in a couple of weeks.

ATP%20dyno%202.JPG


ATP%20dyno.JPG
 
what numbers did you produce on runs 2 and 3?

edit: and how much did they charge you to put it on? I heard those things are a real PITA.
 
PRacing said:
You'll love the new upgraded Turbo... I upgraded mine last week.

Guess I won't be the only GT Turbo's Speed6 in FL anymore :P


where was it installed?
 
it was installed at japtrix, they have a lot of experience and i trust them, i just ordered the gt3071r today, so I'm very exited(and broke!), run 2 and 3 are past runs we were comparing the older runs with the newer ones, everytime I install something new I dyno it to see how much or how little hp and tq I get. so far the car seems to react good with mods.
pracing what part of fl are you?
 
Back