325whp 388nm @ 20psi

[Pirana]

Yeap, but you add the intercooler and piston/rod combo and it goes up

 

[status50]

Congratulations. Once more HiBoost proves their products.

He is the first running our BIG BOOST KIT. This kit is capable of 25+ PSI of boost to get close to 400 WHP.

This is with no fancy components but just what is necessary. A good flow turbo manifold, proper size turbo and good fuel management.

The Engine has our setup with Pauter rods and lower Compression mazda pistons. (not forged)

Turbo is a GT30R
Tial Wastegate
HiBoost HIGH FLOW turbo manifold
HiBoost piston/rod combo
Haltech E6X engine management

This is what comes with the HiBoost BIG BOOST turbo upgrade.


Once again, congratulations Kasman.


Juan

I doubt that. He is running 20psi now and is at 325whp... I would guess he would make nothing more than 360whp at 25psi.. Personally the numbers seem REALLY low for that turbo and the fact that he has a ported head, larger throttle body and built motor. Look at these guys, they have much less:
http://www.msprotege.com/forum/showthread.php?t=109990

And with a smaller turbo and less boost
http://www.msprotege.com/forum/showthread.php?t=108718

http://www.msprotege.com/forum/showthread.php?t=102875


And there's that 505Zoom guy who just layed down 278whp at 12psi on his MSP.
http://www.smokinmhz.net/saltines/build-up_vid_big2.mov

I remember reading awhile back where you said you made 330whp at 20psi with your normal Protege kit(VF22).. Do you have a dyno sheet for that?

 

[Crazee D]

wow...i am impressed