I've been trying to do the programming mode to connect my keyless entry to my car. the process I was doing at first was:
1.open door
2.lock and unlock door using electric switch
3. Put key in ignition
4. Turn key from off(lock) to on three times within 10 seconds then leave off
5. Close and open door three times, leave open then car should center programming mode( signified by the door locking and unlocking once).
those steps never worked until I started turning the key from on to accessory, car still didn't enter programming model but if I turned the key at all it would EXIT the programming mode(lock and unlock twice). Any ideas on why that's happening, how to get it into programming mode? Is there a 6th step? Any input would be greatly appreciated, thanks!
1.open door
2.lock and unlock door using electric switch
3. Put key in ignition
4. Turn key from off(lock) to on three times within 10 seconds then leave off
5. Close and open door three times, leave open then car should center programming mode( signified by the door locking and unlocking once).
those steps never worked until I started turning the key from on to accessory, car still didn't enter programming model but if I turned the key at all it would EXIT the programming mode(lock and unlock twice). Any ideas on why that's happening, how to get it into programming mode? Is there a 6th step? Any input would be greatly appreciated, thanks!