Search results

  1. R

    Let's see some Mazda3 5-doors

    .
  2. IMG_7347.jpg

    IMG_7347.jpg

  3. IMG_7558.jpg

    IMG_7558.jpg

  4. IMG_6939.jpg

    IMG_6939.jpg

  5. IMG_7296.jpg

    IMG_7296.jpg

  6. IMG_7295.jpg

    IMG_7295.jpg

  7. R

    How to: Install TRZ Transmission Mount

    Thank you for this how to! It made a big difference since my factory mount was trashed!
  8. R

    Question about the "Raven" wing

    I like the Raven wing so I'm hoping someone that has purchased one responds to this thread. Here's a few picts of the duckbill wing with paint.
  9. 88ccb2e4bf6aabe0-large.jpg

    88ccb2e4bf6aabe0-large.jpg

  10. 88ccad6fbb506fd6-large.jpg

    88ccad6fbb506fd6-large.jpg

  11. Screen shot 2010-10-29 at 9.59.06 PM.png

    Screen shot 2010-10-29 at 9.59.06 PM.png

  12. 30432_729537409085_6400345_41548584_7580611_n.jpg

    30432_729537409085_6400345_41548584_7580611_n.jpg

  13. R

    WTB: '04 Mazda 3 17in 5 Spoke Wheels

    If your wheels are not bent it would probably be best to have them stripped and powder coated. They can match the original color and make them look brand new for $60-$80 per wheel.
  14. R

    Check Engine Light troubles

    Are you getting the code P0126 or P0128? The print out should say: 1.) Check Coolant Level, 2.) Thermostat Defective, and 3.) ECT sensor defective. I would try changing the thermostat first. I have read a lot of people fixing the problem with a thermostat change. I would pay for the factory...
  15. R

    2005 Mazda 3 2.3L shaking while stopped in drive

    It's probably the motor mount on the passenger side or the tranny mount on the drivers side. I would change both of those as well as the rear mount since your car is 5 years old. If you pop the hood there's a good chance you will see some fluid around the passenger mount. The rubber used on the...
  16. R

    Mystery Hex Nut

    Thanks Clifton, I think I figured it out. Me and a friend were installing the rear motor mount, header and exhaust a few months ago. It looks like it's the factory rear motor mount fastener. The CP-e came with new hardware so the this is probably the original. I was a little freaked out when a...
  17. R

    Mystery Hex Nut

    I removed my skid plate today and a 1 3/32" hex nut fell out. Does anyone have any idea where a nut this large would have come from?
  18. Hex_Nut.jpg

    Hex_Nut.jpg

  19. R

    Aftermarket/Custom Bottom Mesh Grille?

    These are expensive but look great <http://www.racemeshgrilles.com/racemeshgallery.htm#RX-8>
Back