Search results

Is it possible for the moderator to create 2 sections one for the gen 1 and the other for the Gen 2 cx9's like in other vehicle forums?

Was just wondering if anyone has ever changed their front sway bar bushings on their first gen cx-9. How difficult is it to do..?

I was wondering if anyone has done an oil change or other diy regular maintenance on their CX-90 yet…If so, please do tell, thanks!

So I was just wondering if cylinder deactivation on the Mazda3 works in the exact same way as the one in the Hondas.

According to the mazda website the stated lenght of the cx-9 is supposed to be 199.8 inches. When I measured the length of the 9 it measures 195 inches and that includes the bumper bar I installed on the rear bumper. Is it common for vehicle manufacturers to exaggerate the lenght of a vehicle?

Has anyone purchased a mazda extended warranty for their CX-90. How long can you extend it years and miles and how much does it cost with 100 and o deductible options.

Just wondering if anyone has experienced this yet. When I turn on the radio it sounds fine when I turn on the electric rear defogger the reception is affected. It sounds like it's breaking up staticy. Anyone else has had this. What might be the cause? Any suggestions would be greatly appreciated.

Hi, all. Would like to know if anyone has the part no. to the drivers side cx9 headlight socket and wire harness for the low beam. The one on my car fell apart when i was trying to change the low beam headlight bulb. All info would be greatly appreciated. The one i have is 07 cx-9.

I have used the search function to search for the person who had posted that their revised dealer installed control arms have failed. Can someone post a link where i can find this, thanks.

Good Morning, I have one question. I have to replace one tpms sensor on my 07 CX-9. If I get a Mazda one, Do I have to use a scan tool to make it work on the car. Or is it plug and play where I don't need to do anything but drive it a few miles for it to set? Any input would be greatly...

I was wondering if anyone on this forum has seen this type of container of fl-22.

I have a leak in the nipple that comes out of the radiator which is next to the drain plug. I squeeze the hose and nothing comes out,then i squeeze the plastic nipple same result. After a while it gets wet again with coolant. Is it the hose or the radiator. Also does anyone have a part number to...

Good Evening everyone. I was thinking about replacing the thermostat on my gen 1 cx-9 2007. I ran an estimate through repair pal and it listed the replacement at 708 to 731 dollars. Is the thermostat replacement that expensive? how much is the thermostat and is there anything else that needs...

There is a little box on the front of the engine compartment that contains 2 relays and one fuse. I would like to know if the tyco relay which the cover says is for the fan is for the radiator fans or if not what is it for?

Hi all. I would like to know if i can use 2007 ford edge front calipers on my 2007 CX-9? I noticed that the part numbers from autozone are almost the same except that the cx-9 has an s after the a in the part number where as the edge only has the a. Any help would be greatly appreciated. Almost...

Today I go to the wholesale club 18 miles away. Car started and ran fine. I got home, an hour later when I tried to start the car I would hear one click and that is it. I first checked the battery with a multimeter and it read 12.1 volts and the green light was on the meter indicating a good...

Does anyone have any idea why I get this chirping noise. I hear it inside the car while driving. It's on and off. What is it that i need to replace. At first I thought it was the blower motor but it happens even when it's off. Any help would be greatly appreciated. Thanks in advance.

I have noticed that quite a few of the second gen owners have reached 40k miles or more on their 9's. Have any of you service the transfer case yet ( changed fluid ) if so how did the old fluid look.

When I am parked I hear a popping noise when I turn the steering wheel left or right. This just started happening today. I have new strut assemblies, the control arms that mazda replaced and about 2 year old tie rod ends. What can be causing this popping sound. Any help would be greatly...

Hello I would like to know what parts i have to remove in order to get the front strut assembly out on my 2007 CX-9. I am pretty sure that the stabilizer has to be unbolted from the strut. Do i have to remove it and what else do i have to remove or move out of the way. Thanks in advance for the...