Search results

Ok, here is what I finally came up with and will be installing tomorrow. 30A Relay 87 - Fog lights 86 - Ground 85 - Mini blade fuze tap to 15A fog light fuze in EC fuze box 30 - Power All wires will be 17A because the three stores I went to only had 5A, 17A, and 27A. There will also be a 15A...

There is a front relay for the fogs. Just looked at mine. Now, if I wanted to use a relay would this be the correct config: 30 Amp Relay 87 - Both fog lights 86 - Ground 85 - Fog light switch (front fogs) 30 - Power (would a 15 AMP fuse be sufficient?) If so, what amp wire would be best...

I did read one person say they were going to wire rear fogs to the front fogs but all they noted was the use of a relay, not much of anything else. Correct, I just didn't like having an obvious single fog light with a toggle switch. Front fogs are not required/inspectable, only rear are...

I recently purchased the iJDM rear fog/brake light assemblies and was hoping someone had a wiring diagram to tap into the existing front fog lights. While the assembly does state to tap into running/brake lights the requirement here in the UK is that the fog lights must be operated separately...

Yea, the MOT is pretty specific that placement doesn't matter as long as it is viewable from the front, white, and "marks" the approximate width of the vehicle. No, the ambers can stay as long as the white lights are there. Now I just need to figure out the wiring of everything because most...

I ended up purchasing the Fog Light Assembly with LED DRLs from iJDM which instead of connecting to the DRLs I'll connect to the parking light. Got the rear fog light assemblies as well which meets the MOT requirements.

Yea, I'm not a fan of having to use the resistors but the only other option would be to use LEDs in the front fog lights and configuring it where the parking light option was a low intensity and turning on the fog lights would use full intensity. Guess it comes down to which one is going to be...

Hello everyone. Recently arrived in the UK and need some advice on meeting the parking light requirement here. Per law when you turn the selector knob to parking lights option the front should be white instead of amber. Does anyone have experience with this? I read an article where you can...