Search results

You mean 2 valves labeled Low and High? I unscrewed the plastic cap on the L valve today and heard a small blow. As if some air had passed away. It's weird. It may hiss, but when we press the valve. Maybe you're right. I have to run the air conditioning and test the uv lamp with the...

thanks for your comments. One mechanic says maybe you should get to the evaporator under the dashboard. I have a green dye in my system. I will buy uv lamp as you say. I have to see under the car where the pipes go to the second row. I must see the second blow in the tunnel. Nobody looked there...

I don't want to laugh at it. Cx 9 from 2019 in my hands. I did 3 air conditioning services and there is always little gas. 120-160gr. The rest run away. I had a hole in the aluminum tube under the coolant reservoir. this has been fixed. Unfortunately, the air conditioning done in the spring...

Hello, did any of you have a problem with the air conditioning? Does the mazda cx9 have a weak point in the air conditioning system? Air conditioning packed 9 months ago and the air conditioning is not cooling anymore. 2 services claim that the air conditioning system is tight and good. So...

Hello. I found the cause of the keyless failure on it. The problem is in the key card. I press the center of the card and the LED blinks every 5 seconds. I press the card and the handles work, the engine also starts from the card. I will give the remotes to the site where they will improve...

Will someone give the exact place where the keyless module is? I know around the steering wheel. Anyone have any photos? What number is on the module?

Do you mean keyless go module or alarm module?

do you think i have a problem with the rear keyless antenna for it? Is there any way to check the antenna? please help.

So after replacing the module, I have to go to the Mazda Dealership? Can such programming be done with forscan?

You mean the module keylessgo is damaged ?

My friend. You mean keyless go?

Strange. I light up normally a few times. sometimes I have to use a key. Yesterday I was driving without the key light blinking and today it is flashing. Can I replace this module myself or do I have to go to the mazda service? Do the remotes need to be programmed?

The engine sometimes fires from the card. Then the key flashes while driving

I still have a problem with keyless. Engine starting works once and then I have to insert the key. Once every 10-15 times the button in the handle works but most times it does not work. Forscan shows an error as I wrote above. Could that be the keyless antenna on the back under the bumper?

Moja Mazda 2008 ma 70 mikronów lakieru. Co mnie zadziwiło, dach ma 40-45 mikronów i cynk. Mazda sama ocynkowałaby dach?

I think it's the battery's fault. The new duracell has 3.20V and the previous one, also the new one, was 2.97V. There is an improvement. I can almost always start the engine with a keyless entry

Code: B1600 - PATS ignition key transponder signal is not received. - Possible causes - - Defective ignition key - PATS antenna or cables damaged - Damage to the PCM Module: Opening the door locks with a remote control (no keys required)

Today I noticed that the right rubber from the handle button is broken. Right door button. Could this be the reason the keyless actuation is not working well?

do you mean the immobilizer module? Where can I find him? under the steering wheel or on the radio? Thank you for your help

Have you seen my movies? What's wrong with the card? Or maybe it's the fault of some antenna.