Search results

It's only $14, Lubegard Platinum. 😊

I can't stop. I had my first shot of ATF additive recently and it felt good. 😭 I think additives are more accepted on domestic and euro forums. I respect the mods here and appreciate their work. Last night I wrote something redundant in a post and woke up this morning to a better structured...

I have been wanting to attend an Additive Anonymous meeting. Is it Hotshot, Sta-Bil, or Heet? 😅 Sta-Bil small engine quick fix helped start my mini moto after it sat for 5+ months.

Put everything back, including the resonator, and NO tape over the hole between the inlet and resonator. While the car is in motion, fresh air enters from the top inlet opening, feeds into the tub below the panel filter, and also down into the resonator. The temp in these parts is closer to...

From reading the specs of CS SRIs, the inner diameter of the silicone pipe (coupler between TB and MAF) for CX-3 (2.0G) is 3". It is 3.5" for CX-5. The stock snorkel is not designed to restrict airflow, but the short ram setup supposedly allows for more air flow. I like the CS cold air box that...

Because of NA, I suppose? With forced induction, the air gets pulled so the lack of restriction is beneficial.

I wanted to see if this setup offers any benefit beyond the increased noise. If there is none, then the snorkel will go back in. 😬 Any MPG gain isn't worth the change in how it drives. I wonder if the cone filter in the CS setup works as the narrow passage way (enclosed chamber) to reduce...

Got it! I don't know much of the science behind all this and have to try and find out. 😁

I took it out and the car performs differently. The stock box is still in there with the panel filter and taking loose air straight from a large hole. I suppose the narrow and curved inlet passage helps getting air ready for use? Not sure if the temp made the difference. 🤔 Perhaps I need to wait...

Also added the quick-disconnect for the negative terminal. It is basically two pieces connected together by the green knob. There's a plastic barrier between the two pieces. When the knob is off, ground is disconnected. They are tight as of now, but I will need to recheck. When the knob is off...

Today I removed the inlet parts of the intake. Will see what difference it makes beyond sound/noise. The rubber tube from TB to MAF has become harder to remove. It used to be easy, now I have to pry and push with two hands. Don't want to use a flathead yet. There are a couple of reasons why I...

I was considering the CorkSport SRI for my CX-3 and have decided to hold off while I experiment with the stock box without inlet snorkel and resonator. Would have deleted this post but will edit it instead when I am ready to pursue further. 😁

It works well on wood puzzles too. I would color the bare sheets before brushing oil on. Update: During email exchanges over a recent UOA, it occurred to me that these puzzles/models are better off at an oil lab. 😁 Shipped the few intact ones off today. Also ordered two models that I haven't...