Recent content by vimo19

Thank you

how hard is to replace the rear wheel bearings on a 2004 mazda 3 w\o abs?

I had the same thing a couple years ago,Shift Solenoid in the Transmission was bad. They replaced it, cost me $250.00 at the Mazda dealer. Never had that problem again.

Pawtucket , RI

It could be one of two things , ( or both ): 1) Purge Solenoid Valve. 2) Dirty Thrttle Body. Very common , I did both and the car runs like new , with 110,500 miles .

You got air in the system. 1-run the engine at 2500 rpm for 5 minutes, 2-then run it at 3000 for 5 seconds. Repeat steps 1 & 2 two times.

Disconnect the battery for 1 minute or more.Reconnect the battery back. Without turn the engine ,Turn the key to ON position for 1 minute. Turn Key to off position for 1 minute. Turn engine on , let it warm up to normal tempeture after that let the engine run at idle for 5 minutes.Turn...

No sound during turns but both struts are blown (oil leak all over the struts)

The boots are not torn, I had the dealer changed the stabilizer bar bushings but that wasn't the problem.

Anytime I drive the car turning or going straight and I still got the stock suspension (96,000 miles)

I have a 2004 Mazda3 Hatch,when I'm driving slow over bumps or uneven road,I get a Clunking sound from the front.What could be the problem?

Check out www.Rockauto.com and look for Mazda-2008-3S-2.3L-Body- Exterior-Headlamp Assambly.

Left side = BN8F510L0E Right side = BN8F510K0E

Deleted it.!!!!!!!!!!!!

I know, I checked with another dealer and they want $190.