Recent content by Shermer321

I have a slightly used AWR passenger motor mount that was redesigned to fix the lowering the engine fault from the original (About a 1/2" taller). It has about 800 miles on it. I am selling because my car is selling... It is an 88 durometer and the vibes are not bad at all but the noise is a...

I have a like new SURE rear motor mount for the MazdaSpeed6. Selling the car and this aftermarket part is going first! It was purchased on 05/07/12, I can show receipt. So you can be assured it isn't worn out. Just a few marks from tapping it in place. SOLD!!!!!!!!!!

Dibs! PM sent.

BNR Turbos, made for the Speed6 with no boost creep like the GT but still has a GT core. HIGHLY RECOMMENDED. Stage 1 for stock RELIABLE replacement. Check out their website. Or for your HP needs check their Stage 3.

I have the stock sub wired up to my KVT-614 and the little guy gets loud (Sloppy). A sealed sub sounds WAY better.

Dibs on TWM

I'm interested in the TWM Short Shifter. Anything wrong with it?

So.... other than a door, anything left?

Sold

As the title states I have a ProSport 52mm Electrical Boost gauge that was installed for a couple days. Took out because I want to use 60mm gauges. This gauge looks amazing with the 52mm Defrost Vent Gauge Pod. The pod works great and has no cosmetic or physical defects. I would like to get 35...

Cobb Does anyone know if I have a Cobb intake, can I still use the economy map (it highlights in the note STOCK INTAKE ONLY? And can't I run a stage 1 map with just an aftermarket intake, without exhaust or test pipe upgrades?