Recent content by sandyj

Unichip Update question Hey All, So I went a ahead and got the 626 manifold, and will be installing it in the next few weeks. I will not be able to get a custom tune for a while. So my question is if I run 10psi (SMIC, K&N panel filter, &TB) with this manifold on the factory unichip map, will I...

thanks, I have similiar mods to you. If I can pull similiar numbers , I would be happy! hopefully the 626 IM does not mess things up

what was your total HP/TQ ?

great thanks, that sounds good, by the way what kind of numbers were they able to get you with a custom tune?

ok, thanks for the response, I guess I will decide if I want to get it then, really don't want to get it if it is going to be more of a pain to tune then its worth? What kind of issues have you experienced while tying to tune with it, AFRs going all over the place? thanks

So, Is it that it is much harder to tune the unichip with the 626 IM, or it can't be tuned at all with it? thanks

Ok, thanks for the quick response JDM SAM, I forgot to mention that I am flashed, not sure if this changes things. But I will be running 100+ octance, so I should be fine on Map B. Will I be gaining much power though? In regards to the 626 manifold, you don't recommend it because it has...

Unichip update Hey Guys, So I never got the EBC to hold boost properly on the unichip, It is spiking to about 15/16psi. So I put in the spring in the meantime until I get it tuned (waiting to put the 626 mani in first). I was just curious, on the high boost setting on the unichip does only just...

I currently have a K&N drop-in with the bottom of the stock boxed opened up. Wiith my currents mods of TB, SMIC and Unichip will I see any gains by upgrading the intake to a CAI or SRI? I could not find any dyno results of intakes. Would it be even worth upgrading it after other mods like the...

Thanks for the responses if I were to run 100 octane on Map B and only 10psi, this is still not safe?

Thanks..sounds cool I will give that a try when I get the chance

Ya I hooked it up according to the instructions... so one of the lines is off of the factory tee from the stock bov. The other lines from the solenoid run to the wastegate and the line from the crankcase. Where do you recommend that I run it from? Thanks

Installed the Unichip ok so I installed the unichip this afternoon...install went longer then expected, but it went ok. I took it out for boot on the stock setting and map A. The car felt good, a little smoother. Then I swtiched to the high boost settings. I did a couple of pulls in 2nd and...

thanks for the reply , my bad for not posting it under the unichip stickynot sure if I can move it there now. You say you are running the SS afc on the stock super map with you mods, so this will be the same as running the hiboost setting on the unichip? you are running 10psi?

Hello Everyone, This is my first post, I have 2003.5 mazdapspeed with the current mods SMIC, K&N drop in and vibrant TB Exhaust: I just bought the unichip and from what I read I should be fine with the factory maps? If I were to add a Cai, 626 manifold, and some hard pipes is it completly...