Recent content by NCoppersmith

Selling Haltech E6x with PnP Harness Already Wired. $500 Had to sell my MSP due to moving so I'm selling my Haltech that was never installed. All you get is what you see. I don't have the software CD (get it from the Haltech site) or anything else that may have gone with it. Purchased about 5...

Hey all, discovered a weird vacuum issue the other day and wondered what it could be. If the fan control is turned off, I pull ~20hg of vacuum, sometimes a little less. But if I turn the blower fan on (no AC, just vent) I drop to about 14-16 and the engine starts idling ragged. Turn the fan...

Mad props to the OP on this. I had this problem on my MSP that had been in storage in Michigan for the last five years and only just started driving it again. All the part numbers matched up, and cost about $120 from some online place in California. Mine was rusted as heck as well, and ended...

The speedometer in my MSP got "sticky" where it would jump between 45mph and 60mph depending on how fast you were going, not giving a good, gradual, needle sweep indicating speed at certain ranges. So, even though minor, I decided to swap the gauge cluster, thinking I could swap the PCB without...

Is the gauges the whole cluster or just the gauge faces? I'll take the whole cluster shipped to 29223.

Are you selling the instrument cluster? I'm shopping for one shipped to 29223.

I have some 15inch steelies with Blizzaks mounted on them currently with less than 5,000 miles on them. They were on my P5 and then I moved them to my 'Speed, but they work flawlessly. I drove around in Michigan winters with them so they've already been broken in. :) I'm in South Carolina now...

What kind did you want? I have an E6x that I never installed, it's been sitting in a box for the last 5 years along with a custom harness I had made for the Protege so you don't have to cut into the stock harness.

I just had a HKS SQV v4 installed in my MSP and it's currently hooked up to VTA. I have the Injen CAI hooked up in SRI configuration, and the mechanic attached the recirculation line from the old, stock BPV directly. (so the intercooler recirculates to the hot side of the CAI directly with no...

The glowshift ones are exactly what I want. Would that fit in any single DIN opening? I should be able to just pop the compartment out and put that faceplate in and it all works, correct?

I have 3 gauges, all Innovate Motorsports XD-16's that I need mounted. I tried the A-Frame pillar option but didn't like it. I thought I saw somewhere a cutout or mod for the over radio compartment that could be used to mount gauges, which I think I'd like to try. Does anyone know if this is...

Hey all, got my MSP out of storage and getting it road worthy. Had it tuned up by my mechanic and one of the things I had them look at was the gas smell when the engine is running. The EVAP is fine, the line pressurizes correctly, and there are no leaks in the system. The mechanic said he...

Are the taillight assemblies the same for the P5 and Mazdaspeed? I think I have the same ones but they're badly yellowed and wouldn't mind replacing them.

Are you parting out the interior? I'm unsure if the interior colors are the same, but I need a gray drivers side A-pillar trim piece, shipped to 29223.

Do you have the instrument cluster available yet? Also I'm looking for the A-Frame trim piece for the drivers side.