Recent content by lvl3catastrophe

I appreciate the info. I will have to see which sizes these links come in. Do you know which lengths that are available? I will read the forum tonight.

I checked the Cork Sport site they only have the front strut bar for the Protgs. Is there another place I can look?

Other than AWR what other front adjustable links are there. I have agency power links in the rear they have done me well so far. I need a set of front links to replace the ones that came with the Megan Coilover kit.

Does anyone know of some good adjustable front end links for a protg 5? I need to replace the ones that came with my Megan coilover kit. They are longer than stock so I need it to be able to go up to around 8 inches. The only ones I have seen are the AWR links. Please let me know if anyone knows...

That does look pretty good.

Thanks ScratchNSniff, I appreciate the advice

Also is there a good shop in Atlanta for future reference?

Appreciated the advice. I don't really have any other issues with the car though. I just did a full tune up and replaced all the fluids, thermostat and coolant hoses. The timing belt was replaced about 20k back and with that the water pump. Anything you think I should keep an eye out for?

I appreciate the response. I will try the fuel hose route. I just noticed the stay is there is just moved about 2 inches away from the bushing. Should it be that far away? If not about how much space should there be? The progress sway bar in the back has no space at all.

Ok I have had a noise from my front suspension for a while now and everywhere I took it couldn't figure it out. While working on my car this week I noticed that the rubber sway bar stay on the driver's side is no longer there. Now the sway bar can move laterally with just me pushing on it. I...

I am running the agency power endlinks. They have done me good over the past year. They should fit the stock sway bar fine, but I am running the progress rear sway bar and megan coilovers. The site shows that they only fit the Mazdaspeed protg but they fit the MP5 also. I hope this helps. I...

I wanted to get the engine top end of my P5 redone because I am at 240,000 miles and figured I should do it. Wanted to see if anyone knew any good shops in the Atlanta Georgia area. I was thinking of going to either Mazmart or Mainstream. Please let me know if you have any suggestions also if...

No is that what what people usually use to stop this from happening? I know there isn't a washer up there at all now though it didn't come with one.

I wanted to know if anyone has had or has a remedy to this problem. I have Megan's street series coilovers MR-CDK-MP501. There has been an issue with the top mount bolt loosening about every six months since I installed them 2 years ago. When the issue comes back there is a clicking noise when...