Recent content by jaxmsp

AFC for sale I'm in on the 1st group buy and need to sell my AFC also...if any one wants to send me $295, PM me or post here and I'll ask DSMConvert to ship it directly to you instead of me.

DSMConvert: I've e-mailed ya and posted the same question to the forum without answer: which boost map is the AFC going to be pre-loaded with?

Which map will be pre-loaded on the controller? Do we have a choice?

Ok MSP gurus, got a good question for ya. My MSP runs like the devil for the first 5 minutes or so after a cold start. But after the engine warms up to normal operating temp, the power falls off a bit, most noticably from 2nd gear on. Now before you dismiss this as heatsoak, consider the...

I thought people were having probs with these hoses cracking when they tried to do that. Also, isn't that T fitting glued to the hose? Must take a careful hand to do it right. Thanks!

So how did you do it?

Semi noob question here. Is it possible to install a boost controller such that when it is removed, there is no trace of the installation? Looks to me like you have to replace or cut the vacuum hose, or remove the tamper-resistant clamps to install a boost controller. Doing any of this is...

Several have asked on this thread or the other: Does it have to be spliced/wired in, or is it true "plug" and play???

subscribing

I may well be an idiot, but at least I haven't succumbed to vendor-driven marketing hype and biased testing results (this time). There is a an aluminum-superiority groupthink going on here. People, aluminum is a heatsink. Do a little research or talk to a materials engineer iif you don't believe...

We do not know how these temps are being measured. If these test results are from measuring the temp of the pipe itself, then the aluminum "cold" pipe metal will measure cooler than that of a steel pipe. That's because the pipe, which is conducting heat from the engine bay, is transferring its...

Glad it was worth the wait!

So you had the intercooler independently tested by a third party, yet you are unwilling to divulge who that third party is? Most companies that realize such good results with their products (as you have indicated with your intercooler) seem proud and anxious to have an independent third party...