Recent content by HI-RES

its a Hurricane 4-1 header made by an australian company called Liverpool Exhaust. it wouldnt be worth your money to buy it & get shipped to USA, cheaper to just get a custom set copied to the OBX design.... anyways anybody vote yes for nitrous

My 1.6 has a header / CAI / 2.25 exhaust / ngk ignition leads and a 1:1.7 fuel regulator (sitting in the garage)........is that enough to support nitrous? I would love the hiboost kit but costwise its over $8000 AUD to buy, ship, taxes/customs, then install..... compared to less than $2000...

Man thats pretty wack, sorry to hear it. If I cant be part of the group buy then how do I go about ordering from you, do I have to pay full retail I guess? Ken if its any consolation, I've ordered plenty of stuff from the states before and know how the customs system works. If this header is...

yah ok... well I plan to put a 20mm rear swaybar on the back, front strut brace (not sure of thickness) and a set of SPC camber pins front & back. I've just been warned by vendors that the standard GC kit is not designed for illuminas, hence my caution. On the other hand it seems alot of...

what kind of life do you think I'd get from putting GC on my tokico illuminas? And will the stock standard GC eibach spring rate be ok..... would be a PITA for me to order custom rate springs (being in aust)

GTR badge??

shane what colour is that? i dont think i've seen it in australia, looks good! are those erebuni front bars much of a pain to fit?

well for whats its worth this thread is in the 1.6 tuning forum and there was only 2 out 11 people of the GB stating 2.0ltr.... sorry i thought that was obvious. I'm all for helpin each other out but ur response tangled up what I was asking or maybe i interpretted it wrong. anyways it doesnt...

Of course a little low end torque will be lost with the new cat, I mean to say I dont need to lose anymore by putting in an oversized pipe and slowing down the gas flow so I have to rev hard to get anything out of it. And of course I have a 1.6, and no, bein smart ass doesnt help anyone..

2.25 for a 1.6ltr is an overkill, 2" mandrel is enough. Dont want to lose any low end torque (its bad enough already). yeah most exhausts are that size (dont know about 3 though) but are they specifically designed for the 1.6? or are they for the 1.8 & 2.0? And just because they sell them at...

so i guess u guys had them custom made? is there any way i can get in touch with the manufacturer? cheers

guys does anyone know what size the downpipe outlet is from this header???? i want to use 2" pipe all the way through but worried might be 2.25"

hey guys where can these eyelids be bought from???? http://www.msprotege.com/forum/attachment.php?attachmentid=49750

nice. ken can i pay by credit card as banking with foreign currencies is a bit of a pain. cheers