Recent content by felixd

  1. F

    DIY CX-5 Steering Column Clunking. EPS Gear Damper Replacement

    Yes man , untill you hear this type of Bloody clunky noise and very much annoyed you when driving. This steering column assy have the similarities setup with Toyota brand.
  2. F

    DIY CX-5 Steering Column Clunking. EPS Gear Damper Replacement

    Hey peeps, just going to leave it here. Hopefully someone needed it. Mazda CX-5 Steering Column Clunking. EPS Gear Damper Replacement.
  3. F

    Mazda not starting due to busted starter cable

    Best it to remove the starter unit and check what needs to be replace. If the wire needs replacing perhaps sourcing from a wrecker?
  4. F

    P0304 Error. Help tried everything!

    Have you swap one of the coil pack to cyl 4 and check if the other cylinder has the same problem ? then you can assume that the ignition coil pack is the problem. Also check if any intake vacuum hose are worn out / have cracks on them & check PCV Hoses under the intake manifold.
  5. F

    2013~2016 Mazda CX-5 Strut Shock Absorber Replacement

    The reason i choose this brand they are value for money for parts made in Japan Osaka. Quality wise very similar to OEM ones. But we will see Hopefully they last long just like the OEM ones.
  6. F

    2013~2016 Mazda CX-5 Strut Shock Absorber Replacement

    Yes that is coming very soon . 😁👌🏻
  7. F

    2013~2016 Mazda CX-5 Strut Shock Absorber Replacement

    Mazda CX-5 Shock Absorber Replacement .
  8. F

    Idles at 500 RPM, noticeable vibration

    have you check OCV / VVT Valve unit if its operating properly ? I would also check the intake valves if its caked up…
  9. F

    2013~2016 CX-5 CV Axle Repair & Refresh

    Hi y’all, hope you guys are well, just like to share it here. Godbless 👍🏼 Mazda CX-5 CV Boot Axle Repair & Refresh.
  10. F

    DIY How to clean Camshaft Position Sensor (2.0L & 2.5L Skyactiv)

    Well i did not have any issues with my CX5. But if you were having issue with your CX5 as per below you want to check on these sensor. A dirty Camshaft Position (CMP) sensor can cause a range of engine problems because it sends inaccurate information to the car's computer. The most common...
  11. F

    DIY How to clean Camshaft Position Sensor (2.0L & 2.5L Skyactiv)

    How to remove and clean CMP Sensor Exhaust side. Mazda CX-5 2.0L & 2.5L Skyactiv.
  12. F

    DIY How to troubleshoot Purge Valve Solenoid Mazda CX-5 2L & 2.5L

    after driving about 10 15 mins around the block you will feel the engine is hesitating to idle normally. You will get Low Idle most of the time like the car is about to stall.
  13. F

    DIY How to troubleshoot Purge Valve Solenoid Mazda CX-5 2L & 2.5L

    I had to replace it since its getting really annoying. Mazda CX-5 Purge Valve Solenoid Replacement
  14. F

    DIY How to troubleshoot Purge Valve Solenoid Mazda CX-5 2L & 2.5L

    How to troubleshoot Purge Valve Solenoid. Erratic & Very Low Idle.
  15. F

    Need help with replacing HID Lightbulb (2014 CX-5)

    How to Upgrade Headlight Xenon HID to LED Bulb D4S. Mazda CX 5 2012 - 2014. Installation guide. Hope this helps.
Back