Recent content by fastasmsp

On hold pending sell to Marko 18

bump

bump

2003.5 Blue Mazdaspeed Protege asking 11,000 OBO Phone # 409-350-1805 ask for Mike Hampton, VA 60,000 miles Mods Mirotech LT-10 EMS 440cc Injectors Perrin Fuel Rail Walbro High Output Fuel Pump AEM O2 sensor and Uego Gauge Mental Addiction Motorsport Front Mount Kartboy short shifter and...

here is his email tech@joepmbc.com. On the fcd there are two black wire one goes to ground and I think one goes to the green wire on the MAF. I know that the wires does not matter which goes to ground and which goes to the MAF. Here is the link to the instructions...

he told me but it has been to long and i dont remember. but mine works just fine at 10psi

if you call or email joe he will tell you how it should be hooked up.

Can any one get me a list of sites to order parts. Anything would be helpful thanks.

If you cut the inside lip off the fender you all should be good to run a 225

i have been running it like this for 2 years. u only blow things up when u dont know what u are doing.

the car is not tuned for it

I tryed me friends and it did the same thing. cars differ to each modd

good but not fast. i to tune it to get any horsepower out of that 15lbs. right now its at 201 FWHP 228 FWTQ

the bc that came with the unichip made my car run from 9-18 lbs so i am running my own bc and that is the most boost i can run before the car leans out

but without tune it those maps are not going to help, because all cars differ in what they need to run right