The mount does not use adhesive tape. It does however snap in place. I have not given any thoughts on how I would remove it if I needed to. I would probably use one of those non marring prying tools. Other than that I'm extremely happy with the mount. The others I've seen put the mount in...
Finally found a phone mount that works and is in the perfect spot. I have seen this phone mount before but found a lot of people disappointed that it wouldn't work because there were no open slots to accommodate the vent wheels. This fit my 2018 CX-5 Touring and has the open slots for the vent...
It appears that the only descent wiper blades out there are the Bosch Envision. Has anyone had a chance to check out the new silicone wiper blades from Rain-X?
https://www.rainxsiliconewipers.com/
Could someone kindly show a picture of the storage box fitted with the sliding tray. There have been so many pictures and links on this thread its been kinda hard keeping up. I've looked at some of the pictures and can't see how its possible to reuse the sliding tray as it has to hang on...
To All,
I'm looking to install an electronic beep module in my 2013 CX-5. I need to find 2 wires. The one that controls the door lock to unlock it as well as the one that locks it. I've installs this on my 2007 Honda Civic and it works great. It beeps once when I lock the vehicle and twice...
Just saw the new 2016 model and noticed the new fog light layout. Has anyone taken interest in retro fitting them on an early model? They look pretty cool and I'm wondering if its an easy swap. Wonder about the cost as well.
Thanks to those who tried to help me out. I went to the TomTom website and found the answer. I failed to reset the NB1. You do that by turning on the car without the SD card, shut off engine and wait about 10 seconds, re-insert the SD card. No more issues with the jittering screen at a...
Has anyone run into a problem with their navigation screen? I'm at a complete stop and the screen starts to twist and turn. My portable Garmin doesn't even do that. Has anyone run into the same problem and resolved it? I have the latest firmware updates and I have yet to complain to the...
Thank you so much for the info Zeal Red. Love this website. Unfortunately I don't have the Tech Pkg and that's where I'm missing the headlamp stabilizer. I'm guessing that I can hook up the white wire to the positive lead on the headlight bulb which should trigger the LEDS off when I turn the...
I'm a little confused. I'm looking at the directions and I can't figure out where to tie in the White and Blue wires. Can someone clarify? I'm going to be ordering them soon. Also, where is that headlamp stabilizer located in the engine bay? Is that where you would tie in the white and blue...
My bad. I got the neoprene 2. They are the CR grade neoprene. They totaled over $600 for the front and back, not $400 as I mentioned earlier. Sorry (hide).