Recent content by bucd

  1. B

    Deciding where to buy a new engine!

    How many miles on your old motor before you heard knocking? Im just curious. Thanks D
  2. B

    Buying 2003 Pro5...need some input/advice.

    I just picked up an 03 as well. ~118k miles. Looks at front end stuff. Just more wear over the years than miles put on it. Sway bar bushings, end links. Lower control arm (mine was actually bushings on these, but mine as well do the whole thing with new ball joints), outter tie rods. My...
  3. B

    Custom made Light Bulb holder

    That's correct, it actually holds it tighter than the other side that has the wire clip. -D
  4. B

    Custom made Light Bulb holder

    Hello all, So I picked up an 2003 Protg 5 recently. So far had to have most front end work done. Sway bar endlinks, bushings, front wheel bearings. Will be doing lower control arms, outter tie rods and cv axel seal on Monday. I also replace tranny filter and gasket, and used Lucas...
  5. B

    Protege Front Wheel Bearing Service - LOTS OF PICS

    Thank you sir. So any RTV to block the hole is ok? -D
  6. B

    Protege Front Wheel Bearing Service - LOTS OF PICS

    Bringing this post from the dead. Just wanted to confirm something if someone can help. So if i get either one of these, do i still need to buy the wheel seals? I want to order all the parts at once and have them ready to go. 03 P5 here, i know it has the drain hole, but i'm not sure if the...
Back