Recent content by Blake D

  1. B

    Ssafc problems

    why are you above 4k and not mashing on it? when i had a afc it got rich after 4k. if you tune the map you can lean it out some but i wouldn't go to far. may also be in some settings in the afc.
  2. B

    What have you done to your MSP today?

    What setup? And numbers when your done. Going for mine in a couple of weeks.
  3. B

    What have you done to your MSP today?

    boost leak, bad plugs, plugs not gaped properly, this list could go on of things you should check
  4. B

    New P. E. P/Pope Downpipe and turbo manifolds.

    motor mounts should be on your list. at minimum front and rear with side inserts.
  5. B

    New P. E. P/Pope Downpipe and turbo manifolds.

    i know when i put mine on i noticed it helping on the bottom end and the top end both. it didn't seem to choke out as bad in the upper rpm and spooled a little faster on the bottom. huge difference from the stock piece. you can almost fit the stock inside it. even if you had someone build you a...
  6. B

    What have you done to your MSP today?

    i dont understand why its doing that. i never had any problem with it on my car. but every car is different.
  7. B

    What have you done to your MSP today?

    there's no base timing maps available. At least none I've found.
  8. B

    Mazdaspeed protege parts

    Check your inbox good sir.
  9. B

    What have you done to your MSP today?

    i would love to just buy the whole car if i had the money.
  10. B

    What have you done to your MSP today?

    im still having no luck with my transmission... this is starting to just be more of a nascence. ive had this transmission out 3 times in the past few weeks... but on another note i cut the ssftc out and got my haltech started laying out. going to be a fun project here.
  11. B

    Building boost but not going faster

    if you just walk into a parts store they will give you the wrong plugs. stock replacement plugs are NGK PZFR6F. make sure there gaped between .28 and .32
  12. B

    What have you done to your MSP today?

    I haven't had a problem with my clutch bearings. I just have mine adjusted to where it feels good. It may be bad bearings. As far as the transmission bearings go there not bad to make sure there not hard to make sure there still in spec when you replace them. Probably won't even notice a...
  13. B

    Tire upsize?

    They should fit. Just really need to check fitment in rear. Your speedometer should stay the same. Or at least you won't notice a difference. As far as tire size. They should be able to just order you the proper size and won't be no more expensive. If there a decent shop they would have looked...
Back