What have you done to your P5 today?

Ok I just looked at some other pics, I guess its normal for them not to be welded all the way around the pipes at the very top (coming out of the engine)? neat? but yea some one explain the cross member thing to
 
My exhaust just recently started hitting the crossmember as well (CS exhaust and Kartboy hangers) - it didn't do it at all a week ago and now everytime I get on a decent hill it just starts bouncing off the crossmember. I'm almost worried my s-pipe broke... can't check it until it stops raining though!

On another note my new second O2 sensor came in - yay! Now only if the rain...
 
Ordered my osram low beams on the 19th , waiting for them to get here from the UK. I may end up selling them and going with those $130 HIDs in the group buy section.

How much of a b**** is it to get the HIDs aimed, so that I pass inspection?
 
I polished and sealed my Enkei RPF1s so I can have the tires mounted tomorrow. Holy crap, MUFF was right, they may say 205 but they are HUGE! I set one next to my Kumho V700 r-comp tires, 225 width and it was almost identical in width O_o
 
Ordered my osram low beams on the 19th , waiting for them to get here from the UK. I may end up selling them and going with those $130 HIDs in the group buy section.

How much of a b**** is it to get the HIDs aimed, so that I pass inspection?
supa easy. i did it in 4 minutes seriously
 
Put a CB Radio and PA sys in my car today. Dropped the PA speaker in the CAI housing! So far Iv'e had it for 12 hours, and had soo much fun messing w/ people!

Any other Protege5's w/ PAs?
 
My P5 has now been upgraded to the "Broken, but needs to be a daily driver status."
 
It's not P5 related, I know...but...

attached is one of the pieces of the block that I picked up off the ground...
 

Attachments

  • 07-24-07_1644.webp
    07-24-07_1644.webp
    29 KB · Views: 203
I sat in the passenger seat for another drive to work. I miss driving the Pfizzle. I need my ankle to be better NOW.
 
Back