Anyone using an AEM patch harness?

[jitters]

Is anyone using an AEM patch harness? Were you able to get everything to tuck back under the floor panel? I've connected my SSAFC and Safeguard to the patch harness but can't get everything (ECU and harness) to fit under the floor panel. Any suggestions would be appreciated.

 

[Alamo1]

It's a mess of wires under the floor plate in my car.... I made my own harness from an ecu I gutted from the wreckers. I got the plate back into place by bending the top tabs and only using the top two nuts connecting it to the firewall. I may fab up a new plate this coming winter but no problems for right now as I normally dont have many people ride along.

 

[destineal]

bump for more advice

 

[Alamo1]

Just to clarify, I dont think you could ever get the plate to fit back into place with that huge bunch of extra wires under it...

 

[Spiced MSP]

Ran into the same issue with my Haltech EMS. Haven't thought of a solution yet since I took the Haltech back out for the time being. May just end up using Velcro on the connector and sticking it to the floorboard under the carpet or something

 

[destineal]

Pics?

 

[Spiced MSP]

I don't have it installed right now. I probably won't install it again for a while. Need the car to be driven, I can't keep the car down any longer trying to tune it. So, I'll be running stock ECU again for a while since I'll be slowly getting things ready for a build hopefully soon. I'll be driving up to JDMSam to get it tuned and since Im on a GT30, he strongly recommends bigger injectors to do a conservative tune on the car until I build. So, I'll be ordering a minimum of 725cc injectors before installing the Haltech again. I'll also be buying "someones" stage 3 integrals soon

 

[destineal]

Sounds good.