fs-de

Hi, I am looking to purchase some forged Pistons and Rods for a turbo setup and are hoping I can get some advice on suppliers. I'm a long way from the U.S. (New Zealand) but shipping is usually easy. Some opinion on brands of rods and Pistons would also be great. Been a long time in the...

I just grenaded my 2002 P5 engine and am looking for a direct replacement. Original engine had 162,000 miles on it. Been driving this since new and def don't want this to be the end of it! If anyone has a long block, let me know what you want for it. Thanks so much! -Justin

Was driving from New York to Ohio and experienced an overheating condition. 2.0 FS-DE, all stock, 217k miles, broken A/C compressor, A/C always turned off. I stopped the car when the temperature gauge went to 75%. Oil level was normal, and coolant fan was working, but I topped it off anyway, and...

First post to Mazdas247 Forum. I rebuilt a 2.0L FS-DE engine with new rings, bearings, valve stem seals, valve grinding, seals, gaskets, timing belt, idlers, water pump. It has good dry compression at 150psi in each cylinder. However, I cannot get the new motor to idle for more than a minute...

Hey guys, Im thinking about getting some headers for my Fs-de motor. But my question is, will it have an "Check engine light" for removing the Pre cat?

PN: 9999-95-193D-98 http://onlinemazdaparts.com/partlocator/index.cfm?action=AccessoryCatalog&catalogid=4778&siteid=214264&categoryID=92295 Cheaper???

I'm new here and have a 2003.5 MSP with 157k miles and. it smokes pretty bad every morning thick white smoke so I'm wondering I found a 2000 jdm fs-de 626 motor and was wondering if it would swap into my car easily.

hey i thought id post this its a diagram for the fs engine 96-97 as well as cali set up, hope this may help someone as well, i had a egr issue and vaccum lines were backwards, long story short the chiltons book from autozone sucked and i picked this up from the Army help manuals its an adobe file

Hey everybody, I have recently aquired a login to all data diy, which shows break downs and trouble shooting procedures for the mx6 2.0 fs series cars. i will not give out my password but i am willing to give out e copies on any and all subjects that one might want. all i ask in return is that...

Hey i am new to the forums but not to mechanics, i built my fs-de with fs-ze internals, over bored pistons, j-spec cams, the whole 9 i got 10k+ in the block alone. when i crnak th ecar over it does not start, it motors but wont completly fire over. the crank is TDC so are the cams, now i have...

I'm looking for a G15M-R transmission for the 2.0L FS-DE somewhere in the southeast. needs to be manual :D