cam

So I did a rebuild on my MSP and installed forged rods and pistons as well as had everything resurfaced. Well now I have everything together and the car will not start. So first I checked to make sure all the wires were correct and they were. Then checked the sparkplugs and they all spark. So I...

Ok ill start off with what this engine is going to have FS-DE block: .5mm over boor, 10.4:1 pistons polished and balanced crank all new tighter tollerance bearings aftermarket piston ring set FS-DE Head: Mild to medium port and polish 3 angle valve...

pretty interesting stuff! http://www.ecutek.com/products/proecu/flashcan/mazda_disi/ I sure hope someone tries this out soon. Dont wanna jump off the boat first. Seen a post on the mazda6 forums no results