2.0

  1. Chris_Top_Her

    Skyactive 2.p0op Emission recall (ECU reflash)

    Hi there is a recall out for 2.p0op L skyactives of the 14-15 MY. It relates to this issue "Lack of power under hard acceleration during cold weather". You can check your VIN here. http://www.mazdausa.com/MusaWeb/displayRecallOwners.action If you are tuned, at least with OVTune, you are to...
  2. U

    Rebuilt Engine, Bad Idle

    First post to Mazdas247 Forum. I rebuilt a 2.0L FS-DE engine with new rings, bearings, valve stem seals, valve grinding, seals, gaskets, timing belt, idlers, water pump. It has good dry compression at 150psi in each cylinder. However, I cannot get the new motor to idle for more than a minute...
  3. C

    What else can I do to my 2002 Protege ES 2.0 auto?

    This was my first car and I finished paying it off this year so I wanted to have some fun. I have a large income and wanted to throw money into this vehicle but don't wanna go as far as changing the transmission. The car has "paddle shift" so I've heard and here's what I have on it so far: -AEM...
  4. R

    2.3 internals in a 2.0 block? possibilities ? issues? Re-build in progress

    my 06 2.3 threw a rod , i have a 2007 2.0 engine that spun bearings at 70k miles ( swapped engine for friend last year ) have both engines apart in garage 2.3 block is shot , and 1 rod i was thinking could use 2.3 crank / balance shaft delete as the 2.0 does have oil port nor holes for it ...
  5. 2

    New to mazda.engine swap options? 2002 p5

    I just got a 2002 mazda protege 5 the other day and long story short I blew the 2.0 up.it was missing 3rd gear when I got it but that was not a big deal. We have a 2005 2.0 from a mazda 3 with 5 sp OD.its a foMoCo motor I know for sure.can the swap be done cheaply or has it been done?i have...
  6. J

    Inspecting timing belt from valve cover?

    Hey guys, I got my '02 2.0L at 111k miles (now at 161k) and I'm planning on replacing my valve cover gasket this weekend. I'm not sure when/if the previous owner replaced the timing belt before I purchased it, so I may have substantial life left, or may be on some seriously borrowed time! I'm...
  7. A

    mazda cams

    these are the cams that cork sport sells on their page, both intake and exhaust, i bought them and they have literally been installed for less than 40 miles, they didnt work to well with my setup so im selling them, they sounded great and when tuned added some nice power in the mid range...
  8. T

    Mazda Protege 5 2003 Not Running Properly

    Hi Guys I have a mazda protege 2003 2.0l with 143,000kms I changed the plugs but it isn't running properly at all. Its very sluggish when pulling away and going uphill it has no power at all and the engine doesn't pull very well. Ive read alot about cleaning the egr valve on this forum and i...
  9. B

    Full HiBoost Turbo Kit, AutoGrimmig(eBay) Header with Gaskets, Non-Foulers

    Hello everyone. I am looking to get a newer car at the end of the year so I am selling some of the parts I won't be needing for the Protege. Complete HiBoost HB-101 Turbo Kit for the 2.0 Protege Sedan and P5 - $1,300--- Sold to user "slipkornvayne" AutoGrimmig 4-1 Header for the 2.0...
  10. Q

    Easy HP Gain tips

    any one tips on easy horse power gain?
  11. D

    2005 Mazda3 2.3L to 2.0L Engine swap questions

    Just bought a 2005 GT with some engine problems and high km and I want to put the 2.0 engine and trans in the car. I can get them both for $500 with 130K on them so that's why I want to go that route. Since this is my first Mazda I don't know anything about what is interchangeable so any advise...
  12. M

    Looking for calipers for my 2001 protege es 2.0.

    Does anyone know where to buy a set of 4 calipers for an 01 protege es 2.0?
  13. B

    Im looking for a transmission rebuild kit

    I need to rebuild my tranny and i was wondering if anyone knew where i could order (if it exists) a performance rebuild because im on my second tranny and i want to eventually add more power to my protege without worrying about a weak tranny. I have a 2002 mazda protege es 2.0. My stock setup...
  14. 6

    swap 2.2 in place of 2.0

    I have access to a rebuilt 2.2 out of an '89 probe and was wondering how complicated it would be to swap this into my '87 626 that has a 2.0 non-turbo and a 5-speed. The engine also comes with turbo and non-turbo 5-speeds and a complete stock turbo set-up. Anybody have any experience with...
  15. CorkSport

    CorkSport Power Series 2010+ Mazda 3 Single Exit Exhaust

    The CorkSport Power Series 2010+ Mazda 3 single exit exhaust is constructed from polished 304 SS and is TIG welded. The exhaust system is available in hatchback and sedan configurations. The exhaust includes all the needed hardware for installation. All CorkSport exhaust systems include a 2 year...
  16. Antoine

    *Mazda of the Month 2.0* VOTE NOW for JULY!

    Welcome to the Official Mazda Forums "Mazda of the Month" Contest! * The MOTM is OPEN to ALL Mazdas! * Please note the following rules & guidelines. Your cooperation and participation is greatly appreciated...Thank you. ENTRY RULES 1. ANY form of cheating will result in immediate...
Back