What all do I need to run a TPL91-B turbo?

19379huge_turbo1.jpg

this one? its a bolt on. And it has the airflow volume is 55 cubic meters per second. Very Nice upgrade.
 
Last edited:
well it all looks good on paper, but what should i expect for a spool time?

It should start spooling roughly around 40K rpms! The only problem that I see happening is even with doubled valve springs is.... that I will more then likely still float a few valves at that rpms and the stock gauge cluster doesn't go that high so it might break as well.(drive)
 
It should start spooling roughly around 40K rpms! The only problem that I see happening is even with doubled valve springs is.... that I will more then likely still float a few valves at that rpms and the stock gauge cluster doesn't go that high so it might break as well.(drive)


did a fast calculation, dunno if its correct,

55 cubic meter/second = 116 538.398 5 cubic foot/minute

assuming 10lb/min of air = 144cfm

116538.4 cfm = 8092lb/min

Our engine flows 14lb/min of air @ 6500

so....our basically we need our motor rev up to

8092*6500/14 = 3757000 RPM which is much faster than 40k HAHA

correct me if its wrong...
 
did a fast calculation, dunno if its correct,

55 cubic meter/second = 116 538.398 5 cubic foot/minute

assuming 10lb/min of air = 144cfm

116538.4 cfm = 8092lb/min

Our engine flows 14lb/min of air @ 6500

so....our basically we need our motor rev up to

8092*6500/14 = 3757000 RPM which is much faster than 40k HAHA

correct me if its wrong...


yeah... someone has way to much time on there hands.
 
Back