Have been in the process of completly restoring my much loved 323 1.8i GT its cost me a Fortune and its taken along time. and now just as i finish it the last two jobs..
the abs stoped working. the last two jobs (new rear disks & off side Cv joint), the light now stays on the dash board.
I have checked and rechecked the CV we changed even re fitted the old cv back in , still the light refused to go out, the senors apear to line up ok but as i said i tried again the orginal cv an this still didnt clear it, i also rechecked the rear disks i have had them off twice now they are Definatly calibrated correctly and working properly (inclunding h/b), But Still no joy with the abs light, I really cant see that we could have damaged the system, but am at a loss as to why it wont work :-(
after 2 days i still cant find a fault with anything in the breaking system, iv also tried the test mode for the abs using the link between specified in the haynes manual. (no responce) I also tried disconnecting&reconnecting the battery.
Iv not been able to get the diagnostic code from the port as am un certain how to connect up , i have seen diagrams for the 626 but when i checked the pin names on my 323 did not match if anyone has information on getting the ABS code out of a 323 or "any" usefull info regarding reseting or re calibration routines please help.
the abs stoped working. the last two jobs (new rear disks & off side Cv joint), the light now stays on the dash board.
I have checked and rechecked the CV we changed even re fitted the old cv back in , still the light refused to go out, the senors apear to line up ok but as i said i tried again the orginal cv an this still didnt clear it, i also rechecked the rear disks i have had them off twice now they are Definatly calibrated correctly and working properly (inclunding h/b), But Still no joy with the abs light, I really cant see that we could have damaged the system, but am at a loss as to why it wont work :-(
after 2 days i still cant find a fault with anything in the breaking system, iv also tried the test mode for the abs using the link between specified in the haynes manual. (no responce) I also tried disconnecting&reconnecting the battery.
Iv not been able to get the diagnostic code from the port as am un certain how to connect up , i have seen diagrams for the 626 but when i checked the pin names on my 323 did not match if anyone has information on getting the ABS code out of a 323 or "any" usefull info regarding reseting or re calibration routines please help.
Last edited:
