Dual valve setup PICS

[drewski1990]

I have done alot of research on dual setups already so my question is not on how to set up. I just want some pictures as reference when it comes to doing my own I have something to compare with. I am also curious of peoples creativity =]. THXX

One question however, Does the hot pipe have to be custom made to have a flange to connect the BPV? The Ebay Kits doesn't seem to have that flange like the stock pipe.

 

[Ricktalife]

 

[drewski1990]

Very nice setup Rick! Looks very clean, but i forgot to mention the dual setup has to be to FMIC. Basically I am just curious if the hot pipe needs to be modified to connect the BPV.

 

[hornsfan10609]

Yes you have to put a flange on the hotpipe for the BPV like the stock setup. You can run a single BOV and not get any turkey if you buy the right BOV. Apparently the TurboXS type H works well in low boost applications like ours.
http://www.mazdas247.com/forum/showthread.php?111800-Dual-Valve-Forge-BOV-stock-BPV-How-To-pics

 

[drewski1990]

I am getting the turbo XS type H. I just thought it would be better for our cars to have it recirculated. Now to think of it, does it matter at low boost?

 

[Ricktalife]

As a matter of fact, I do have a FMIC. The hot pipe runs through the hole where a SMIC would be, so that I could install it with minimal cutting.

 

[drewski1990]

OHHH! Sry I didn't even see that. Did you have to route it to the left side or does your FMIC have both inlet and outlet on the same side (right)?

 

[drewski1990]

Did you weld your bpv flange onto the hot pipe? I can't seem to find any MSP hotpipes on Ebay that premakes the flange.

 

[Ricktalife]

I bought it used and it was a custom made kit. The hot pipe turns left and goes to the passenger side of the car. It is really long pipe routing, but I wanted to eliminate any cutting of the frame and this kit accomplished that.

 

[505zoom]

I just want some pictures as reference when it comes to doing my own I have something to compare with. I am also curious of peoples creativity =]. THXX

I have a few different ones.


This was the O.G. turkey kill setup:

After that I switched to a MAM FMIC kit and redid everything:

Then I switched to BPV only with my custom FMIC setup, so that's all I can contribute as far as dual valve pics go.

 

[drewski1990]

Very nice. ZOOM. Pix definitely helped alot. On the first pic, it looks like u had it on the cold pipe. Did that setup gave you any turkey at all? I read somewhere on the forum that it was ok to do so. But I liked the second setup alot. MAnn i need that flange on the hot pipe!!

 

[505zoom]

Yup my first setup had both BPV and BOV on the cold pipe. It worked the same both ways... no noticeable difference.

If you haven't already seen this thread, I'd check it out:

http://www.mazdas247.com/forum/showthread.php?123711609-Kill-your-Turkey-V.2

 

[hornsfan10609]

You aren't going to find a pipe with a flange already on it unless it's from someone that already made it themselves.

 

[Johnoolo]

bump