Search results

Hello, I took all the parts off to get too spark plugs now engine wont start. It turns over and for a brief sec it wants to start but won’t. Does the computer need to be reprogrammed and does anyone know the procedure? Thank you, Alex

2007 Mazda CX9 I have oil at bottom of Intake (Plenum)does anyone know why it would be there , Im thinking that it is coming from pcv valve can anyone help me here, Thanks.

Please disregard this post

Hi , my question is , when I rev engine while parked in drive the engine only revs up to 80 kms or so ,can anyone give me the reason why this might happen ,I notice that previous owner has something installed where catalytic converter should be ,do you think that could be the issue here ,thanks...

Hi, I charged battery and polarity reversed now car no start anymore:cry:. Any idea where to start to diagnose this problem. I obtained a good battery but no power to starter. Only lights that come on are dash speedometer. Thanks!

Hi, The problem is that after taking apart everything to get to the manifold to take it off ,I ended up not removing it so put everything back together for some reason the car doesn't idle properly and dies ,any ideas where to start should I scan with OB11 scanner ,would that show anything...

I took my brake apart ,it was stuck became super hot, hope didn't warp something, but suspect piston ring problem ,not sure if rust or bad seal.Would like the manual if possible. Thanks Alex P.S. Hope you are well, see your name everywhere here.

Hi Folks, Anyone know how much fluid the transmission holds ,I have taken off the pan ,will i need to put in the maximum amount that it holds,also should I replace the filter while the pan is off and is it easy to fill the transmission.How do I measure the amount thats in the...

this is the story, I removed the rear calipers and sanded painted and reinstalled but when I tried to bleed them the bleeder screws broke off because of being rusty (toetap) any ideas besides getting new ones Thks Alex

When car is on slight incline and in park the car rolls , trans doesn't hold the car form rolling , anyone can help me here thx Alex

Can anyone out there tell me how to put the proper tension on the alt and time belts , do I need a special tool. Thanks, Alex

looking for a oil pan for protege 5, thanks

hello ,can anyone tell me how to drain the coolant on my protg 5,is it at the bottom of the rad and how would I access it,do I need to take off the plastic shield at bottom of engine ,thanks Alex

can anyone supply me with the link for manual for p5, thanks

Hi Im having power steering problems ,the pump is leaking somewhere ,I see oil below it but cant seem to locate the area where its coming from.It had been making a whining noise as I accelerated for now I disconnected it, took the belt off.I drove car with the noise for some time may have burnt...

Do I really need abs can I just unhook it and drive without it, thanks .I suspect that the speed sensor is faulty and don't want to get a new one if possible

Hi, I have been parking my car on a slight incline in my driveway without the parking brake on and a few times the trans has slipped while I was parking it ,can anybody explain this ,is it a result of parking over the years putting stress on the trans. Thanks Alex

I was thinking can the engine analyser detect if the engine is using too much fuel I smell gas when I start the car lately also it has a hard time starting it turns over more than normal lately

I just put a new stabilizer control link on my car ,the old one was broken in two for a few yrs I would say, now that I drive it I'm hearing a noise like a clunking sound ,I noticed that the rubber on the stabilizer for the other side is cracked but the bar is still intact,do you think that this...

was wondering if I can use the protege tires on my pro 5 thks