Search results

I installed litte bit sound deadening to front wheel wells. First inside plastic liner off and cleaning Then butyl where it could be installed. I actually did put little pieces also to outer fenders. Then plastic liners also got butyl. Didn't put that much because of the increased weight...

Don't know for a fact, but guestimating that MPS3/Speed3 swaybars should fit. I had previously gen1 Mazda 5 and I did swap MPS3 swaybars to it, front and rear. Rear is easy, original was 20,3mm thick and MPS3 was 25,5mm Front was kinda kinky, but doable. Original was 23,3mm thick and MPS3 was...

Needs more information, than just 2013 sport. But without knowing market area, engine size and fuel type, I would say that easiest way to figure it out, is to look engine cover. If it says Skyactive or DISI, then it's direct injection. If not, then most likely it's port injection.

Just remembered this thread! I haven't put a pic from my 2nd gen 5 2011 with 2.0 DISI engine, 6-speed manual. D2 coilovers and mazda 6 19"rims with 235/35 tyres.

Changed thermostat, old one looks ok, but coolant temperature didn't go over 78'c Now temperature rises to about 88'c and stays there nicely. And washed the engine bay after thermostat change.

Yes, it's "suprisingly" easy. Seatbelt bolts were 14mm, and also philips screwdriver is needed to get the sunvisors and front dome light off. Center dome light you don't need to take off, because it's not holding the headliner. And the c-/d-pillar panel don't have to come off, just loose...

I installed little bit dampening to roof panel. There isn't anything attached from factory. I added 2mm stp bytul deadening mat. And over those some more softer 10mm closed cell mat. Headliner went back without any problems. And the differece is really noticable. I would say that...

It's actually really good feature in bad weather, especially in highway driving. And not blinding driver behind me, or if it's, then the driver is too close. It's just 21W bulb, so same brightness as brake lights. I don't use front fogs at all, but have used rear fog many times. As you said...