Search results

When I open the SuperMap Stock the settings is already set .But I know now that i also need to set setting when I write data from ecu to PC.

I open customer SUPERMAPSTOCK then the setting are: 4 cylinder 4 stroke Vacuum/pressure and Programmable signal calibrator Pressure 0 to 30psi/3vdc aux fuel pump abortive start time over pressure inj a and b over latched over rpm 6000 over pressure 1.1 over inj% 90% fuel pump start psi -1...

Yes but i cant and dont know why I redid my wiring get 12.5v to the split second....car starts ran fine as **** and then....burp burp burp...stall s***.let the car sit for the night and came in start like a charm ran fine again for 1 hour then....stall again. I made a new vacuum to be sure there...

CONTACT -there is a way to tell me if the wiring isnt making good contact? ( I soldered them so in my mind the contact cant be bad this way) UNIT WRONGLY PROGRAMMED - there something that hint me the unit is wrong programmed. In the map already in the ecu the settings options are Display Mode...

Yes it is. V1 i think because I only have 7 wire and only fuel table. running with r4 v1.5 with HL-340 wire with ch340driver installed correctly and my com port is number 1.I run r4 when key on/engine off.press write in the fuel maps,right after the 3 loading(map a and b) escape, disconnect from...

Ive put yellow/black on purple grey (tachometer) Green to light green/black to maf Purple to light green/black to ecu Pink wire to pink/blue between Y(shield wire black) and ecu Pink/blue to pink blue Red to white/red (positive) Black to black/red Pin out and wire colours were matching...

There are all soldered but it got a plug to unplug it maybe thats the problem ?? I Will connect them directly because this wire doesnt seem to be from factory. Sometimes when its connected it act like a mouse going everywhere on my desktop ?? And where i see my com port its show that the port I...

i installed a used Split second afc v1. i can read the map in afc but i cannot mine in !! Got MAF sensor circuit A check engine and crank sensor circuit A too !!!!

Yeah i know that for now i cant datalog but can i add something to make it work.v1 and v2 are probably the same board just 4 aux input added to it.if yes where are the wire connected on the board .

No way to get widdband datalog from adding a connection on my ssafc v1 ??

the afc is 7 wire and the serial who connect to it is 9 pin for the v1 and v2 version of the ssafc. The are 4 aux input on the v2 so probably 4 of the 9 pin are used to send data to the pc. I have a vacuum that come from the afc that i dont know is use for. So my question is : can i solder a...