Search results

Yellow is the manual trans. I added a label. When I get the manual trans one off, hopefully tomorrow. I can take a close look. Very difficult to tell when it is on the car.

I would try cleaning those drain plugs out first to see if that prevents leaking. They are not to hard to clean out. Get a trombone cleaner to do it https://www.amazon.com/dp/B0B324WXWM/ That is what is used on Miatas to clean out the drains for the convertible roof.

Rallycross?

Thanks for the links. that link about the LH engine mount... that is actually the Right side of the car so it is the Right engine mount. There may be a difference between the auto and manual ones for that side. Very difficult to tell. Here is the auto trans, which looks to be less than two...

Well, I am looking at the Right Motor Mounts on the two cars and they look the same. Manual - front and rear had previously been done by a shop. So, I am just gonna do the right (ordering one for an auto) and the manual trans mount. Front still looked good. Auto - Gonna order a SKP kit and...

It's motor mount replacement time... Just did them on my daughters Mazda 3 and she was driving the Blue Auto P5 while I did the job. She came back and said "it vibrates at 60 mph just like the 3". I checked and sure enough the right motor mount is cracked... So I checked my manual P5 and it is...

I get a 'jumpy' speedo and tach when first starting the car and the temp has been in the 20's F (or below). Basically the speedo and tach both jump up to where they should be and then drop back down to zero. Once the car warms up everything is fine. Anyone else experience this?

FYI - I run 10w40 high mileage in the summer and 5w40 in the winter. Both of my P5's have about 215k miles. Heavier weight helps a little. I recently got rid of my sedan and it had 345k hard miles (4 yrs pizza delivery). It started burning a lot of oil around 250k, 3-4qts over a 3500 mile oil...

If you pass with it, it is most likely because it wasn't noticed. I guess you could... clear codes, put the non fouler in, run until all OBDII checks are complete, remove the non fouler (as close as possible to the inspection station), then get it inspected.

I have only replaced front calipers. I have used Wearever - Advance auto Raybestos - Rock Auto I have not had issues with either brand.

They are just making sure that year, make, and model are not enough info... They want to make sure you also memorize your VIN for the guy at the parts counter :)

Tailight or maybe hatch would be my guess. Mine leak on the other side around the fuel filler.

Made a video of changing the spark plugs https://youtu.be/T3mDdrsBil8

I am guessing it is something wrong in your linkage. IME when a transmission goes you get 'slipping' e.g. your revs go up but your car doesn't go any faster in certain gears. Also, if the RX-8 has requires the same Spec trans oil as the P5 and Miata... I would go with Motorcraft MTX-75 part no...

I tried one more time. This time I was going to use my air compressor/tire inflator. I warmed the car up till the engine was hot and not just warm. Thing pulled right out. No need to use the air compressor :) One of the spark plugs was very loose and another spark plug was Denso, while the...

Can't get needle nosed pliers in. I tried warming the car up and then using a bicycle pump to pop it out. No joy. It is due for a timing belt (which is not something I am will to tackle). Shop would have to get this off for a timing belt. So, I am gonna punt and let the shop take care of...